Overview
The G2 Axle and Gear 2-2011-300 is a 3.00 ratio ring and pinion for the Ford 9 inch rear axle. It is sold for the rear location and matches the Ford 9 inch axle type.
G2 says its performance ring and pinion sets are engineered for oversized tires and high performance engines, using the latest technology and materials. A 3.00 ratio gives less torque multiplication at the wheels than higher numerical ratios.
Key features
- 3.00 ratio rear ring and pinion
- Ford 9 inch rear axle type
- Built for oversized tires and high performance engines
- Made with current technology and materials
Lower ratios and cruising
A 3.00 ratio is a numerically low gear, so the engine turns more slowly at highway speed and the vehicle pulls with less force at the wheels. That suits light tires and mostly road use, where quiet cruising and fuel economy matter more than low-speed pulling power. Drivers who change to larger tires often find this gearing feels sluggish off the line.
Gears of this ratio can make towing or climbing hills harder, so the choice depends on how the vehicle is driven. Before swapping, check that the carrier and pinion setup match the new set, and inspect the axle bearings and seals for wear.
- Compare ratio with tire diameter before buying
- Check the carrier type on the Ford 9 inch
- Replace pinion seal during the install
- Recheck gear oil level after the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2011-300 |
| UPC | 631410111613 |
| Gear ratio | 3.00 |
| Axle location | Rear |
| Axle type | Ford 9 inch |
| Popular axle manufacturer | Ford |
Vehicle fitment
No vehicle model or year is tied to this 3.00 set. It is built for the Ford 9 inch at a 3.00 ratio, so confirm the housing size before ordering.
Only the Ford 9 inch is named for this 3.00 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 3.00 Ford 9 inch gears should be set by a driveline shop, followed by a break-in period.
What’s included
A 3.00 ring and pinion set for the Ford 9 inch.















