Overview
The G2 Axle and Gear 95-2025-101 is a one piece replacement axle shaft for the AMC 20 rear axle, made for the driver side of 1976–1981 Jeep CJ models fitted with the one piece axle kit. It has 29 splines.
The shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications, which helps them handle the added load of high torque use.
The 95-2025-101 is a one piece shaft for the AMC 20 rear axle, with 29 splines. It goes on the driver side of the Jeep CJ and is forged from high grade alloy steel, heat treated to exceed OEM specifications. The fit covers 1976–1981 CJ models with the one piece axle kit, so confirm your CJ5 or CJ7 before ordering.
Key features
- One piece shaft design for the AMC 20 rear axle
- 29 splines
- Driver-side shaft
- Made for 1976–1981 Jeep CJ models with the one piece axle kit.
- Alloy steel forged and heat treated.
- Rolled splines among G2’s stated design features
Driver side fitment checks
A one piece axle shaft ties the wheel to the differential, so its fit depends on both the axle and the drivetrain setup. Before ordering, confirm that the rear axle uses the one piece design, since a conventional axle takes a different shaft. Measure the spline count on the old shaft and compare it with the differential side gears. Confirm which side the old shaft came from so the new shaft goes on the same side.
Axle shafts wear at the spline ends and at the bearing journal. Look for twisting, rounded splines, cracks near the flange and dry or leaking seals. Shaft replacement is also a good time to check the axle bearing and brakes, since the wheel has to come off to reach them. Clean the splines and apply a light coat of the recommended grease before the shaft goes in, and tighten the retaining hardware to the specification for your vehicle.
- Confirm the rear axle is a one piece design
- Count splines on the old shaft
- Check the bearing and seal while the wheel is off
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2025-101 |
| UPC | 631410096682 |
| Product type | Replacement axle shaft |
| Axle type | AMC 20 |
| Axle location | Rear |
| Shaft position | Driver Side |
| Spline count | 29 |
| Stated application | 76-81 Jeep CJ w/One Piece Axle Kit |
Vehicle fitment
It fits 1976–1981 Jeep CJ models fitted with the one piece axle kit.
The shaft is meant for vehicles using the one piece axle kit, so confirm your CJ5 or CJ7 model year and axle setup before ordering.
Installation notes
- G2 words the application around the one piece axle kit, so confirm your rear axle is set up that way.
- The 29 splines of the shaft have to match your AMC 20 differential.
What’s included
One driver-side one piece axle shaft (95-2025-101).
Not included: The 29 splines have to match the differential gears.







