Overview
The G2 Placer Gold Series Dana 44 JK 35 spline rear chromoly axle shaft, part 195-2052-35, works on either the right or left side. It is built for 35 spline aftermarket lockers and comes with wheel studs and wheel bearings for 2007–2014 Jeep Wrangler JK models.
The shaft is forged from 4340 chromoly steel and made in the U.S.A. It has a dual bolt pattern flange for 5 x 5 and 5 x 5.5 bolt patterns, and the forging carries more material in its critical areas.
Key features
- Rear shaft for right or left side
- 35 spline shaft for 35 spline aftermarket lockers
- Forged 4340 chromoly steel
- Dual bolt pattern flange for 5 x 5 and 5 x 5.5
- Includes wheel studs and wheel bearings
- Made in the U.S.A.
Wheel bearings and studs at install
A complete axle shaft with studs and bearings saves time, but those parts still need to be checked against what is being replaced. Bearings should turn smoothly without roughness, and studs should be straight and fully threaded. Fitting new bearings with correct seating and preload keeps the hub stable under load.
The locker and axle housing are the other key checks before installation. The spline count must match the locker, and the housing should be clean and free of damage. Brake components near the hub are also worth inspecting while the wheel is off, since they are easy to reach at that point.
- Match the spline count to the locker
- Clean the housing before fitting the shaft
- Check the hub and studs for damage
- Re-torque wheel nuts after the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 195-2052-35 |
| UPC | 631410113013 |
| Axle type | Dana 44 JK |
| Position | Rear |
| Side | Right or left |
| Spline count | 35 splines |
| Material | Forged 4340 chromoly steel |
| Bolt pattern | Dual bolt pattern flange, 5 x 5 and 5 x 5.5 |
| Includes | Wheel studs and wheel bearings |
| Locker compatibility | 35 spline aftermarket locker |
| Origin | Made in the U.S.A. |
Vehicle fitment
Fits 2007–2014 Jeep Wrangler (JK) models across the covered trims, from Rubicon and Sahara to Unlimited X.
Wrangler TJ and YJ models, and LJ and JL models, are outside this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Compare the included wheel studs and wheel bearings with the parts you remove before you start the job, and confirm that your locker is a 35 spline unit.
What’s included
One rear axle shaft with wheel studs and wheel bearings.
Not included: locker.










