Overview
The G2 Axle and Gear 95-2049-002 is a Dana 35 rear replacement axle shaft with 27 splines and a 29.04 inch overall length. It fits 1990 and newer Jeep Cherokee (XJ) and Wrangler (YJ) models.
It is built from forged high-grade alloy steel with heat treatment that exceeds OEM specifications, and it is made to handle heavy torque. With 27 splines, it only engages gears cut for 27 splines, so check the differential before choosing it.
Key features
- Replacement shaft for the Dana 35 rear axle
- 27 spline with a 29.04 inch overall length
- 5 on 4.5 inch bolt circle
- Takes 1/2 inch press-fit wheel studs
- 2.840 inch pilot
- Fits 1990 and newer Cherokee XJ and Wrangler YJ models
Axle shaft wear signs
A rear axle shaft works under constant torque and shock, so wear shows up in a few predictable ways. Vibration that grows with speed, a clunk when the throttle changes, or grease on the inside of the wheel usually point to a shaft, bearing or seal problem. A bent shaft can also cause a wobble that feels like a tire balance issue.
When replacing a shaft, check the bearing, seal and axle flange at the same time. A new shaft running on a worn bearing will fail quickly. Clean the splines and the flange face, and use the correct wheel studs and lug nuts for the hub.
- Watch for vibration that changes with speed
- Inspect the wheel bearing and seal during the job
- Clean splines and flange faces before fitting
- Check lug torque after the first drives
Specifications
The 95-2049-002 is a replacement axle shaft for the Dana 35 rear axle, with 27 splines and an overall length of 29.04 inches. Every figure in the table below is the manufacturer value for the 95-2049-002.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2049-002 |
| UPC | 631410103342 |
| Part type | Replacement axle shaft |
| Axle | Dana 35 rear |
| Axle shaft location | Driver side per the attribute listing; the feature list says passenger side |
| Spline | 27 spline |
| Overall length | 29.04 inches |
| Bolt circle | 5 on 4.5 inches |
| Wheel studs | 1/2 inch press-fit wheel studs (not included) |
| Pilot | 2.840 inches |
| Application stated | 1990 up Cherokee XJ, Wrangler YJ |
Vehicle fitment
By chassis code, it covers the 1990-2001 Cherokee (XJ) and 1990-1995 Wrangler (YJ).
It suits 1990 up Cherokee XJ and Wrangler YJ vehicles.
Measure the shaft you are replacing and compare it with the 95-2049-002 listing for spline count, length and side.
Wrangler (TJ) and Comanche vehicles fall outside the 1990-up Cherokee XJ and Wrangler YJ range. Confirm fit for your vehicle before ordering.
Installation notes
The shaft takes 1/2 inch press-fit wheel studs, which are not included. G2 gives conflicting side information, so confirm whether a driver or passenger side shaft is needed before ordering.
What’s included
One axle shaft.
Not included: Wheel studs.






