Overview
The G2 Toyota 9 Inch IFS 4.88 Ratio Ring and Pinion, part 2-2062-488, is a front gear set at 4.88 for a Toyota independent front suspension axle.
Made from computer heat treated 8620 steel, these gears are shot peened and double lapped. They are built to original equipment specifications and carry a 10 year warranty.
Key features
- 4.88 gear ratio
- Front axle position
- Works with any ratio carrier
- Computer heat treated 8620 steel
Front axle considerations
Independent front axles use a different gear and carrier layout from a solid front axle, and the front differential sits in a tighter space. Before installing a front gear set, check the carrier case, pinion angle and axle shaft seals, since the work often reaches those parts. Any joint or CV component that has been running with wear should be inspected at the same time.
Front gear sets take a little more care during setup. Backlash and tooth contact need to be checked with the carrier in place, and pinion preload should be set to the carrier’s specification. A short break-in with fresh gear oil helps the new teeth seat evenly.
- Inspect axle shaft seals and replace any that leak
- Check the front pinion seal for wear
- Use gear oil suited to front IFS carriers
- Recheck carrier bolts after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2062-488 |
| UPC | 631410127966 |
| Make | Toyota |
| Axle size | 9 inch IFS |
| Axle location | Front |
| Gear ratio | 4.88 |
| Warranty | 10 years |
Vehicle fitment
Universal fit is listed, but the 9 inch IFS application is named without a model or years. Confirm the Toyota application and the front IFS layout before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Independent front axle gears are set up differently from a solid axle, so gear mesh and carrier preload should be checked before the front end goes back together.
What’s included
One ring and pinion set.














