Overview
The G2 Axle and Gear 1-2013-308 is a 3.08 ratio O.E.M. series ring and pinion for the Ford 8.8 inch rear axle. It is made for the rear location and fits the 8.8 inch housing type.
G2 says its O.E.M. series gears are designed to run cooler and quieter than aftermarket gears. The company contracted with original equipment manufacturers to make them, and a 3.08 ratio gives less torque multiplication at the wheels than higher numerical ratios.
Key features
- O.E.M. series 3.08 ring and pinion
- Ford 8.8 inch rear axle
- Rear axle location
- Made under contract with original equipment manufacturers.
- Designed to run cooler and quieter than aftermarket gears.
Daily driving with a 3.08 ratio
A 3.08 ratio is the lower-torque end of the range, and it suits steady highway driving and light towing. The engine turns slower at cruising speed, which tends to be quieter and easier on fuel than a higher numerical ratio. Acceleration from a stop and climbing hills feel softer than with a higher ratio.
On an 8.8 inch axle, the carrier and pinion bearing setup should be checked during any gear work, since worn bearings are a common cause of noise. Tire size matters too, because larger tires change the effective gearing. Keep the gear oil clean and at the correct level for the axle.
- Check gear oil level at each service
- Look for noise that changes with speed
- Review tire size when changing the ratio
- Use a shop with setting tools for backlash
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2013-308 |
| UPC | 631410092707 |
| Gear ratio | 3.08 |
| Axle location | Rear |
| Axle type | Ford 8.8 inch |
| Popular axle manufacturer | Ford |
| Series | O.E.M. |
Vehicle fitment
This 3.08 set is made for the Ford 8.8 inch at a 3.08 ratio. Verify the housing size before buying.
Only the Ford 8.8 inch is named for this 3.08 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 3.08 gears should be set by a driveline shop, followed by a break-in period on the 8.8 inch housing.
What’s included
A matched O.E.M. series ring and pinion for the Ford 8.8 inch rear axle.
















