Overview
The G2 Axle and Gear 1-2096-342 is a 3.42 ratio O.E.M. series ring and pinion for the GM 9.25 inch IFS front axle. It is made for the front location and matches the 9.25 inch IFS axle type.
The O.E.M. series in this 3.42 set runs cooler and quieter than aftermarket gears. It is made under contract with original equipment manufacturers, and the 3.42 ratio gives less torque multiplication at the wheels than a 3.73 ratio.
Key features
- O.E.M. series 3.42 ring and pinion
- GM 9.25 inch IFS front axle type
- Front axle location
- Made under contract with original equipment manufacturers.
- Runs cooler and quieter than aftermarket gears.
Choosing a 3.42 ratio
A 3.42 ratio is a numerically lower gear than 3.73, so engine speed drops at highway cruising and the engine works less at a given speed. It suits lighter tires and mostly road driving, while trail use with larger tires may feel strained on steep climbs. Gear choice should match tire diameter and typical use.
Gear sets are best replaced as a complete unit, including pinion bearings, seals and shims. Before installing, look at the carrier bearings and the differential case for wear, and keep the old set’s wear pattern in mind when checking tooth contact. Keep a record of backlash and preload measurements so future service is easier.
- Match gear ratio to tire size before buying
- Verify the axle type on the housing tag
- Replace the pinion seal during the install
- Check the tooth contact pattern after setup
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2096-342 |
| UPC | 631410112306 |
| Gear ratio | 3.42 |
| Axle location | Front |
| Axle type | GM 9.25 inch IFS |
| Popular axle manufacturer | GM |
| Series | O.E.M. |
Vehicle fitment
No vehicle model or year is tied to this 3.42 set. It is built for the GM 9.25 inch IFS axle at a 3.42 ratio, so confirm the axle type before ordering.
Only the GM 9.25 inch IFS is named for this 3.42 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
On an IFS front axle, pinion depth, backlash and bearing preload should be set by a driveline shop before the 3.42 gears are run in.
What’s included
A matched O.E.M. series ring and pinion for the 9.25 inch IFS front axle.















