Overview
It is a 4.56 ratio ring and pinion for the GM 14 bolt 10.5 inch rear axle. It works with 4.56 and up carriers and will not fit a 4.10 carrier, so check the carrier ratio before ordering the gears.
G2 says its ring and pinion sets are engineered for oversized tires and high performance engines. This 4.56 set is made from computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- 4.56 ratio rear ring and pinion
- GM 14 bolt 10.5 inch rear axle
- For use with 4.56 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Gear set and carrier setup
A 4.56 ring and pinion changes the final drive ratio, so the driveshaft turns more times for each wheel revolution than it would with a numerically lower gear. That gives quicker response from a stop and more pulling force at low speed, along with higher engine rpm on the highway. The change works best when the carrier, pinion depth and bearing preload are matched to the set as a whole.
Ring and pinion sets are usually installed with a new pinion bearing, pinion seal and carrier bearings, because those parts are not reused once the gears are pressed and set. When inspecting an older axle, look for pitting, chipped teeth, or a whine that rises and falls with throttle. Check the gear contact pattern and backlash again after the first few drives.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2023-456 |
| UPC | 631410093599 |
| Gear ratio | 4.56 |
| Axle location | Rear |
| Axle type | GM 14 bolt 10.5 inch |
| Popular axle manufacturer | GM |
| Carrier requirement | 4.56 and up; not for 4.10 |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits the GM 14 bolt 10.5 inch rear axle at a 4.56 ratio. Confirm the axle and carrier before ordering.
It is built for the GM 14 bolt 10.5 inch and carriers of 4.56 and up. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 4.56 gears should be set by a driveline shop, followed by a break-in period before the axle is loaded.
What’s included
A matched ring and pinion for the GM 14 bolt 10.5 inch rear axle.













