Overview
The G2 Axle and Gear 2-2035-373 is a 3.73 ratio ring and pinion for the rear Dana 70 axle. The pinion turns 3.73 times for every ring gear revolution, a middle-range ratio that gives more low-speed pulling force than the 3.54 Dana 70 set while still keeping highway rpm moderate.
This 3.73 set is made to original equipment specifications, using computer heat treated 8620 steel. It requires a carrier rated 4.10 and down, so the carrier ratio and the Dana 70 rear housing should be confirmed before ordering.
Key features
- 3.73 gear ratio for the Dana 70 rear axle
- Requires a 4.10 and down carrier.
- Computer heat treated 8620 steel
- Double shot peened and double lapped
- Manufactured to original equipment specifications.
- The set carries a 10 year warranty.
Carrier ratio and gearing
A 3.73 ring and pinion gives a middle-range balance between low-speed pulling and highway rpm. Because the set is tied to a 4.10 and down carrier, the carrier ratio is the first thing to match. A carrier that is numerically higher changes the mesh and can cause noise or early wear even when the gears fit physically.
Heat treated steel and shot peened teeth help the gears handle repeated loads. Good results still depend on a clean, correctly set carrier, proper lubricant and a gradual break-in. Inspect the bearing seats and carrier cover during the job so the new gears start from sound parts.
- Confirm the carrier ratio before ordering
- Check the carrier bearing bores for wear
- Use the lubricant type called for by the gear shop
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2035-373 |
| UPC | 631410094268 |
| Axle type | Dana 70 |
| Axle location | Rear |
| Carrier requirement | 4.10 and down |
| Gear ratio | 3.73 |
| Material | Computer heat treated 8620 steel |
| Finish | Double shot peened, double lapped |
| Warranty | 10 year |
| Axle manufacturer | Dana |
Vehicle fitment
This set requires a carrier rated 4.10 and down. Confirm the Dana 70 rear housing and the carrier ratio before ordering, since a numerically higher carrier is not a match.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the set is tied to a carrier ratio, the carrier must be checked before any gear work starts. A gear shop should set tooth contact and preload, then the gears need a break-in period.
What’s included
One 3.73 ring and pinion set for the Dana 70 rear axle, part number 2-2035-373.
Not included: Carrier bearings, shims and carrier parts for the 4.10 and down ratio are not included.
















