Overview
The G2 Axle and Gear 2-2096-410 is a 4.10 ratio ring and pinion for the GM 9.25 inch IFS front axle. It works with all ratio carriers, so the carrier does not restrict the choice of this 4.10 set, and it is made for the front location.
G2 says its performance sets are engineered for oversized tires and high performance engines. This 4.10 IFS set is made from computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- 4.10 ratio front ring and pinion
- GM 9.25 inch IFS axle
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Choosing a gear set
On a GM IFS front axle the ring and pinion sits inside a housing that also carries the differential and the front axle shafts. A 4.10 ratio turns the driveshaft faster relative to the wheels than a numerically lower gear would, which many drivers pick when they run larger tires or want quicker response. Gear choice should follow the tires and driving you actually do, because a ratio that suits one setup can feel strained on another.
Gears rarely wear alone. Pinion and carrier bearings, the pinion seal and the crush collapsible spacer are commonly replaced in the same job, since they set preload and mesh that the new gears depend on. Inspect the old bearings for roughness and the ring gear for chipped or polished teeth. Keep a record of the setup measurements so future service work on the front axle goes faster.
- Replace the pinion seal during the install
- Check the front differential fluid after break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2096-410 |
| UPC | 631410094817 |
| Gear ratio | 4.10 |
| Axle location | Front |
| Axle type | GM 9.25 inch IFS |
| Popular axle manufacturer | GM |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits the GM 9.25 inch IFS front axle at a 4.10 ratio. Confirm the year, model and trim of your vehicle before ordering.
Only the GM 9.25 inch IFS is named for this 4.10 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
On an IFS front axle, have a driveline shop set pinion depth, backlash and bearing preload, then complete a break-in period on the 4.10 gears.
What’s included
A matched ring and pinion for the GM 9.25 inch IFS front axle.














