Overview
The G2 2-2011-529 is a 5.29 ratio ring and pinion for the rear Ford 9 inch axle. It is matched to the axle type, so the housing rather than a model name determines fit.
G2 describes its performance sets as engineered for oversized tires and high performance engines, using the latest technology and materials. A 5.29 ratio is a high numerical gear, so pinion setup and carrier compatibility should be checked before installation.
Key features
- 5.29 ratio rear ring and pinion
- Ford 9 inch rear axle type
- Designed for oversized tires and high performance engines.
- Made with the latest technology and materials.
Before you install
Gear ratio drives how an axle feels on the road and on the trail. A numerically high ratio like 5.29 multiplies engine torque at the wheels, which helps with heavy loads, steep grades and slow crawling. The trade-off is higher engine speed at highway speed and somewhat more fuel use, so think about how the vehicle is used most of the time before settling on a ratio this high.
A ring and pinion swap goes better when the rest of the axle is inspected while it is open. Pinion bearings, carrier bearings, seals and the pinion crush sleeve are commonly replaced at the same time, since they wear under the same loads as the gears. Look for cracked carrier castings, scored bearing bores and loose cover bolts before the new set goes in.
- Check pinion depth and backlash with a dial indicator
- Replace the pinion crush sleeve or shim pack as needed
- Inspect cover gasket and axle seals for leaks after the first drives
- Retorque cover bolts after a short break-in run
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2011-529 |
| UPC | 631410105476 |
| Gear ratio | 5.29 |
| Axle location | Rear |
| Axle type | Ford 9 inch |
| Popular axle manufacturer | Ford |
Vehicle fitment
It fits the Ford 9 inch rear axle at a 5.29 ratio. Check your vehicle’s year, model and trim against the housing before ordering.
Only the Ford 9 inch is named for this 5.29 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 5.29 gears, since a high numerical ratio is less forgiving of setup errors.
What’s included
A 5.29 ring and pinion set for the Ford 9 inch.
















