Overview
The G2 Axle and Gear 2-2056-488 is a 4.88 ratio ring and pinion gear set for the 8.4 inch Toyota Tacoma axle. It is made for use with a 3.54 and up carrier and fits front and rear axle locations.
The gears are made from computer heat treated 8620 steel to O.E. specifications, with double shot peening and double lapping. They are built for oversized tires and high performance engines, and a 10 year warranty applies. Confirm your axle and vehicle details, including model years, before buying.
Key features
- 4.88 gear ratio
- Made for the 8.4 inch Toyota Tacoma axle
- For use with a 3.54 and up carrier
- Computer heat treated 8620 steel
- Manufactured to O.E. specifications
- Double shot peened and double lapped
- 10 year warranty
Choosing a carrier and setup
A 4.88 ratio on an 8.4 inch Tacoma axle changes how the truck pulls, since the driveshaft turns more times per wheel turn. That gives stronger low-speed pull with larger tires, at the cost of higher engine speed on the highway. Choose the ratio around the tires and loads you drive most, and keep the carrier in the 3.54 and up range the gears need.
Gear work on this axle comes down to backlash, pinion depth and preload. Because the carrier is part of the match, check its condition and bearing wear before fitting the gears. New bearings, seals and fresh fluid help the set run quietly, and a break-in drive with moderate throttle lets the surfaces settle. Re-check for leaks and fluid level after the first drives.
- Match the carrier to the 3.54 and up requirement
- Replace bearings and seals with the gears
- Check backlash and tooth pattern before closing up
- Re-check fluid level after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2056-488 |
| UPC | 631410094671 |
| Product type | Ring and pinion gear set |
| Gear ratio | 4.88 |
| Axle size | 8.4 inch |
| Axle application | Toyota Tacoma |
| Axle location | Front and rear |
| Carrier | For use with 3.54 and up carrier |
| Material | Computer heat treated 8620 steel |
| Processing | Double shot peened, double lapped |
| Warranty | 10 year |
Vehicle fitment
It fits the 8.4 inch Toyota Tacoma axle. Check fit by year, model and trim before buying, and confirm the axle size and spline count.
Because no years are given, do not assume every Tacoma generation is covered. Check the axle size, spline count and carrier on your vehicle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring and pinion installation requires gear setup, backlash and pinion depth measurement, and a bearing preload. Professional installation is strongly recommended.
Use new bearings, seals and fluid when installing, and pair the gears with a 3.54 and up carrier.
Follow the gear break-in procedure, check the fluid level, and re-check for leaks after the first miles.
What’s included
A 4.88 ratio ring and pinion gear set.
Not included: a carrier, bearings, seals, shims, differential fluid or installation kit.
















