Overview
The G2 Axle and Gear 97-2034-010 is a Dana 60 chromoly inner axle shaft for the driver side, with 35 splines and a 35.07 inch overall length. It fits 1978-1991 GM Dana 60 and 1979-1993 Dodge Dana 60 front axles.
G2 Axle and Gear builds these high-strength axle shafts for high-torque use. They are forged from high-grade alloy steel and heat treated to exceed OEM specifications. With 35 splines, the 97-2034-010 engages only gears cut for 35 splines, so check the differential before buying. Inner shafts connect the differential to the U-joint at the steering knuckle, which is why left and right shafts differ in length on a front axle.
Key features
- Chromoly inner axle shaft for the Dana 60 front axle
- Driver side, 35 spline, 35.07 inch overall length
- Accepts a 5-806X U-joint
- Machined to accept full circle clips
- Fits 78-91 GM and 79-93 Dodge Dana 60 axles
Before you buy an inner shaft
Inner axle shafts on a front Dana 60 take torque from the differential and pass it to the U-joint, so they see steady load in both forward and reverse. Wear often starts at the splines, where a shaft that does not match the gear set can chatter or slip. Left and right inner shafts are different lengths, so a shaft cut for the wrong side will not reach the joint correctly.
When choosing a replacement, measure the old shaft and compare spline count, length and side before ordering. The U-joint and circlip are the parts most often replaced together with the shaft, because they carry the same torque and are easy to access once the shaft is out. Look for play in the joint, rust on the cross and worn grooves where the clip seats.
- Count the splines on the old shaft
- Measure overall length from the joint end
- Inspect the U-joint for play before reuse
Specifications
The 97-2034-010 is a chromoly inner axle shaft for the Dana 60 front axle (also called Dana 61), with 35 splines and an overall length of 35.07 inches. Its key dimensions are summarized below.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2034-010 |
| UPC | 631410097344 |
| Part type | Chromoly inner axle shaft |
| Axle | Dana 60 front (also called Dana 61) |
| Axle shaft location | Driver side inner |
| Spline | 35 spline |
| Overall length | 35.07 inches |
| U-joint | Accepts 5-806X U-joint |
| Clip design | Machined to accept full circle clips |
| Application stated | 78-91 GM Dana 60 driver side, 79-93 Dodge Dana 60 driver side |
Vehicle fitment
No vehicle year or model list is published for the 97-2034-010; check the manufacturer specifications for the exact application.
It fits 78-91 GM Dana 60 driver side and 79-93 Dodge Dana 60 driver side axles.
Measure the shaft you are replacing and compare it with the 97-2034-010 listing for spline count, length and side.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shaft is a driver side inner part. It accepts the 5-806X U-joint and full circle clips, so confirm those match the front axle.









