Overview
The G2 Axle and Gear 97-2032-007 is a Dana 30 chromoly inner axle shaft for the passenger side, with 27 splines and a 15.82 inch overall length. It is for 1982–1986 Jeep CJ models.
The shaft is forged from chromoly alloy steel and heat treated beyond OEM specifications, which suits larger tires. With 27 splines, it only engages gears cut for 27 splines, so check the differential before choosing it. The inner shaft links the differential to the U-joint at the steering knuckle, which is why the left and right shafts differ in length.
Key features
- Chromoly inner axle shaft for the Dana 30 front axle
- Passenger side, 27 spline, 15.82 inch overall length
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- It fits 82-86 Jeep CJ models.
- Axle: Dana 30 front, standard
- Axle shaft location: Passenger side inner
- Overall length: 15.82 inches
- U-joint: Accepts 5-760X U-joint
Measuring and matching the shaft
The passenger side inner shaft is the shorter of the two inner shafts on a front axle, so it is easy to mix up with the driver side during a repair. Measure the shaft being replaced from the differential end to the U-joint end, and compare the spline count and side before ordering. A mismatched length can strain the U-joint and the axle seal.
Heat treated alloy steel helps a shaft handle larger tires and heavier pulls, but it only works when the shaft matches the gear set. Check the differential’s spline count and inspect the side gear for wear. Replace the shaft and inspect the seal and U-joint at the same time, since they share the same load path.
- Confirm the side marked on the old shaft
- Compare spline count with the differential
- Check the U-joint and clips before reassembly
- Keep the seal area clean during installation
Specifications
The 97-2032-007 is a chromoly inner axle shaft for the Dana 30 front, standard axle, with 27 splines and an overall length of 15.82 inches. Every figure in the table below is the manufacturer value for the 97-2032-007.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2032-007 |
| UPC | 631410097092 |
| Part type | Chromoly inner axle shaft |
| Axle | Dana 30 front, standard |
| Axle shaft location | Passenger side inner |
| Spline | 27 spline |
| Overall length | 15.82 inches |
| U-joint | Accepts 5-760X U-joint |
| Clip design | Machined to accept full circle clips |
| Application stated | 82-86 Jeep CJ |
Vehicle fitment
No vehicle year or model list is published for the 97-2032-007; check the manufacturer specifications for the exact application.
Built for the 82-86 Jeep CJ with a Dana 30 front axle.
Measure the shaft you are replacing and compare it with the 97-2032-007 listing for spline count, length and side.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is the short passenger side inner shaft used on the CJ Dana 30. It accepts a 5-760X U-joint and full circle clips.







