Overview
The G2 Dana 44 4.56 O.E.M. Ratio Ring and Pinion, part number 1-2033-456, is a 4.56-ratio gear set for Dana 44 front or rear axles. It is made for use with a 3.91 and up carrier.
The O.E.M. series is made under contract with original equipment manufacturers. The gears run cooler and quieter than normal aftermarket gears, and the set is built from computer heat-treated 8620 steel, double shot peened and double lapped.
Key features
- 4.56 gear ratio, O.E.M. series
- For use with a 3.91 and up carrier
- Computer heat-treated 8620 steel
- Double shot peened and double lapped
Signs of gear wear
Ring and pinion gears wear slowly, and the early signs are easy to miss. A whine that changes with speed or load, a clunk when shifting between drive and coast, and fine metal in the differential fluid all point to tooth or bearing wear. Drain the fluid and look for shavings when the cover is off, since bright flakes can mean the gears are wearing faster than expected.
When a set is replaced, the pinion bearings, crush sleeve and carrier bearings are often replaced at the same time. Fresh bearings help the new gears hold their preload, and a clean housing keeps debris away from the new mesh. A shop with the right tools can check the contact pattern before the axle goes back into service.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2033-456 |
| UPC | 631410092998 |
| Axle type | Dana 44 |
| Axle location | Front or rear |
| Gear ratio | 4.56 |
| Carrier | For use with 3.91 and up |
| Gear material | Computer heat-treated 8620 steel |
| Warranty | 10 year warranty. |
Vehicle fitment
The O.E.M. set fits Dana 44 front or rear axles. Confirm fit for your vehicle’s year, model and trim before ordering, and confirm the carrier is 3.91 or higher before installing.
Installation notes
Gear mesh and pinion depth need to be set correctly, so have a qualified shop install the set and allow a break-in period afterward.















