Overview
The G2 Axle and Gear 97-2050-002 is a Dana 30 JK chromoly inner axle shaft with 27 splines and a 34.6 inch overall length. It is made for the passenger side of 2007-2009 Jeep Wrangler (JK) models with a front Dana 30 axle, excluding Rubicon.
The shaft is forged from high-grade alloy steel and heat treated beyond OEM specifications, built to handle heavy torque. The 27 splines have to match the gear set inside the axle. On a front axle, the inner shaft carries torque from the differential to the U-joint, and the outer stub passes it on toward the hub.
Key features
- Chromoly inner axle shaft for the Dana 30 JK front axle
- 27 spline with a 34.6 inch overall length
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- It is for 2007-2009 Jeep JK front Dana 30 non Rubicon models.
Matching splines and length
The passenger side inner shaft on a front Dana 30 carries torque from the differential toward the U-joint, so its spline count has to match the gear set inside the axle. Measure the old shaft from the differential end to the U-joint end and compare the spline count and side before buying. A shaft that does not match can bind, fail to seat or wear the gears.
Heavier torque, larger tires and rough trails all load the shaft more than stock use. Inspect the shaft and its U-joint regularly for twisting, rust or play, and replace worn seals and clips during the same job. Checking both inner shafts together helps catch the same wear on the opposite side.
- Compare overall length with the shaft being replaced
- Confirm the side before installing
- Check spline count against the differential
- Inspect the U-joint and clips at each service
Specifications
The 97-2050-002 is a chromoly inner axle shaft for the Dana 30 JK front axle, with 27 splines and an overall length of 34.6 inches. Every figure in the table below is the manufacturer value for the 97-2050-002.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2050-002 |
| UPC | 631410108316 |
| Part type | Chromoly inner axle shaft |
| Axle | Dana 30 JK front |
| Axle shaft location | Passenger side inner |
| Spline | 27 spline |
| Overall length | 34.6 inches |
| U-joint | Accepts 5-760X U-joint |
| Clip design | Machined to accept full circle clips |
| Application stated | 2007-2009 Jeep JK front Dana 30, non Rubicon, passenger side |
Vehicle fitment
It fits the front Dana 30 axle of 2007-2009 Wrangler (JK) models that are not Rubicon, on the passenger side.
Application: 2007-2009 Jeep JK front Dana 30, non Rubicon, passenger side.
Match the 97-2050-002 against your old shaft for spline count, length and driver or passenger side before installing it.
The 2010-2018 Wrangler (JK), Wrangler (JL) and Wrangler (TJ) are not covered by this shaft. Check your year, model and trim before buying.
Installation notes
This is the long passenger side inner shaft for the Dana 30 JK. It accepts a 5-760X U-joint and full circle clips. Confirm the side against the shaft being replaced before installation.






