Overview
The G2 Axle and Gear 197-2050-003 is a Placer Gold Series Dana 30 front driver side inner axle shaft, 18.68 inches long with 27 splines, for the 2007–2014 Jeep Wrangler JK. G2 describes its Placer Gold Series axles as a stronger option for JK owners: new, made in the U.S.A. from 4340 chromoly steel, with a stronger forging that puts more material in critical areas.
This inner driver side shaft is machined for full circle snap rings and uses the larger Rubicon 1350 Series 5-7166X u-joint. It is for use with a 27 spline differential. Placer Gold is the name G2 gives this line, and the 197-2050-003 is its driver side inner shaft for the JK’s Dana 30 front axle. The shaft is longer than an outer stub at 18.68 inches. Some of G2’s own notes call the position front outer while others say driver side inner, so the title and the attribute list describing it as the driver side inner shaft are used here.
Key features
- Driver side inner front axle shaft for the Dana 30 JK
- Forged from 4340 chromoly steel
- Uses larger Rubicon 1350 Series 5-7166X u-joint
- Machined for full circle snap rings
- Made in the U.S.A.
- For use with a 27 spline differential
Replacing the inner shaft
An inner axle shaft carries power from the differential to the front hub, so a worn joint or damaged spline shows up quickly. Before removing the old shaft, note how the snap rings and u-joint are seated. The new shaft needs a matching u-joint and full circle snap rings, so check those parts are on hand before starting the job.
The splines must match the differential exactly. A shaft with the wrong spline count will not engage, and forcing it can damage the carrier. Keep the axle seal clean during install, and fill the axle with the correct gear oil after the work is done. A quick check of the u-joint movement and snap ring seating before driving prevents most problems.
- Match the spline count to the differential
- Replace the u-joint and snap rings as a set
- Check for leaks at the axle seal after the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 197-2050-003 |
| UPC | 631410115833 |
| Axle manufacturer | Dana |
| Axle position | Front |
| Shaft location | Driver Side Inner |
| Axle type | Dana 30 JK |
| Spline count | 27 Splines |
| Material | 4340 chromoly steel, forged |
| Series | Placer Gold |
| Length | 18.68 inches |
| U-joint | Rubicon 1350 Series 5-7166X |
| Snap rings | Full circle |
| Origin | Made in the U.S.A. |
Vehicle fitment
It fits 2007–2014 Jeep Wrangler JK models, including Rubicon, Sahara, Sport, X and 70th Anniversary trims and Unlimited versions.
- 2007–2014 Jeep Wrangler (JK) (70th Anniversary, Rubicon, Sahara, Sport, Unlimited 70th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited X, X)
Coverage ends at 2014; the 2015 JK, earlier Wranglers and the JL are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the shaft uses the larger 5-7166X u-joint and full circle snap rings, fit the matching u-joint and rings instead of reusing the original smaller parts.












