Overview
The G2 Axle and Gear 97-2050-004 is a chromoly inner axle shaft with 27 splines for the passenger side of the front Dana 30 axle on 2007–2014 Jeep Wrangler (JK) models.
Jeep JK owners with the non-Rubicon front Dana 30 use this front right inner shaft to replace worn units. It accepts a 5-7166X U-joint and is machined for full circle clips. It is forged from high-grade alloy steel and heat treated.
The Dana 30 front axle in the JK is a lighter design than the Dana 44 used in Rubicon models, which is why G2 specifically says non Rubicon. The inner shaft here is the short piece that comes out of the differential and meets the U-joint. A 5-7166X U-joint is named as the mating joint, and full circle clips hold the joint in place rather than the older style of retainer. Choosing the correct side is as important as the axle, since inner shafts are not interchangeable between left and right.
Key features
- Chromoly inner axle shaft for the JK front Dana 30
- Passenger side, front right inner position
- 27 splines
- Accepts the 5-7166X U-joint
- Machined to accept full circle clips
- Made for non-Rubicon JK front axles
Side and clip checks
On a Dana 30 front axle, the inner shaft runs from the differential side gear to the U-joint, so its length and joint style set how it sits in the housing. Shafts are side specific, so a right side part cannot be swapped to the left. Matching the joint and clip style on the existing axle prevents a shaft that seats but does not retain the joint correctly.
Full circle clips hold the joint in place and need to sit fully in their groove. Replace clips that are bent or weak rather than reusing them. When the shaft is out, inspect the U-joint for play and check the yoke for cracks, since a loose joint can wear a new shaft quickly.
- Confirm the joint type before buying a shaft
- Inspect the clip groove for wear
- Replace clips whenever the shaft is removed
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2050-004 |
| UPC | 631410113204 |
| Part type | Inner axle shaft |
| Material | Chromoly |
| Axle | Front Dana 30 (JK) |
| Shaft position | Passenger side, front right inner |
| Spline count | 27 splines |
| U-joint | 5-7166X |
| Clip style | Full circle clips |
Vehicle fitment
It fits the 2007–2014 Jeep Wrangler (JK), including Unlimited models. The narrower fit is 2007–2009 non-Rubicon trucks with the front Dana 30, so match the axle on your Jeep before ordering.
The JK Rubicon has a different front axle and is not the target. Wranglers from the 2018 JL generation and the older TJ are outside the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
G2 pairs this shaft with the 5-7166X U-joint and full circle clips. Make sure the clip style on your existing joint matches before reassembling the front axle.








