Overview
The G2 Axle and Gear 97-2032-005 is a chromoly passenger-side front inner axle shaft for the Dana 30 in the 1972–1981 Jeep CJ5, CJ6, CJ7 and 1981 Scrambler. It has 30 splines and accepts a 5-760X U-joint.
Shafts of this build are forged from high-grade alloy steel and then heat treated past OEM levels. The shaft is also machined to accept full circle clips.
The 97-2032-005 is a passenger-side chromoly inner shaft with 30 splines for the standard Dana 30. It accepts a 5-760X U-joint and is machined for full circle clips. It is forged from high-grade alloy steel and heat treated beyond OEM specifications.
Key features
- Chromoly inner axle shaft for the Dana 30
- 30 splines
- Accepts a 5-760X U-joint
- Machined for full circle clips
- Passenger-side inner shaft
- Front axle
Signs the old shaft is worn
An inner axle shaft wears at the splines, the U-joint yoke and the clip groove. Worn splines often show up as a clunk when the throttle comes on or goes off, and a cracked clip groove can let the shaft walk out of the differential. Both problems get worse under trail loads, so inspect the old part before it fails in the middle of a run.
When the shaft comes out, look at the U-joint cups for pitting and check the retainer for cracks. Light surface rust on a passenger-side tube is common, but any play in the joint or a shaft that spins loosely in the gear means the rest of the driveline needs attention too.
- Clunks on throttle changes can point to spline wear
- Inspect the clip groove for cracks
- Check the U-joint cups for pitting
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2032-005 |
| UPC | 631410097078 |
| Product type | Replacement axle shaft |
| Axle type | Dana 30 Standard |
| Axle location | Front |
| Shaft position | Passenger Side Inner |
| Spline count | 30 |
| Material | Chromoly |
| U-joint | 5-760X |
| Axle end | Machined for full circle clips |
| Stated application | 72-81 Jeep CJ |
Vehicle fitment
Application: 1972–1981 Jeep CJ5, 1972–1975 Jeep CJ6, 1976–1981 Jeep CJ7 and 1981 Jeep Scrambler.
The 1981 Scrambler is the only Scrambler year listed, and the CJ6 ends at 1975. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Check the U-joint is the 5-760X type before fitting the 97-2032-005.
- The 30-spline shaft has to match your Dana 30 gears.
What’s included
One passenger-side inner axle shaft (97-2032-005).
Not included: the outer shaft, U-joint and clips for the 97-2032-005.





