Overview
The G2 Axle and Gear 4-YJ2-456M is a 4.56 ratio ring and pinion set with minor installation kits for the 1987–1995 Jeep Wrangler (YJ) with a Dana 30 front axle and a Dana 44 rear axle.
A ring and pinion gear set changes the axle gear ratio, which restores performance and drivability after a tire size change. G2 says its complete ring and pinion kits include everything needed for a gear swap: front and rear gear sets plus the minor installation kits for both axles.
G2 builds these gears from computer heat treated 8620 steel to O.E. specs, with double shot peening and double lapping. G2 says they are designed to hold up to oversized tires and high performance engines.
Key features
- 4.56 ratio ring and pinion gear sets for front and rear
- Dana 30 front and Dana 44 rear axle application
- Includes front and rear matched minor installation kits
- Computer heat treated 8620 steel
- Manufactured to O.E. specs
- Double shot peened and double lapped
- The gear set is covered by a limited lifetime warranty from G2.
Gear ratio and driving feel
A numerically higher ratio multiplies engine torque at the wheels, which helps with heavier tires, steep climbs and slow crawling. The trade-off is higher engine speed at highway cruising, so most owners notice more engine noise. Plan the gearing around the tires and the way the Jeep is used.
A gear swap is a good time to inspect the rest of the driveline. Check the U-joints, the pinion seal, the axle bearings and the carrier for wear, since replacing them together avoids reopening the axle later. Use the gear oil your axle calls for, and check the fill level after the first few trips.
- Match both axles to the same ratio so the drivetrain stays balanced
- Run a break-in period at moderate speed after the new gears are installed
- Keep spare gear oil on hand for the first fill and the check afterward
- Recheck tire size changes against the new ratio before driving
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-YJ2-456M |
| UPC | 631410141306 |
| Product type | Front and rear ring and pinion set with minor installation kits |
| Gear ratio | 4.56 |
| Front axle | Dana 30 |
| Rear axle | Dana 44 |
| Axle location | Front and rear |
| Kit type | Minor installation kit |
| Material | Computer heat treated 8620 steel |
| Manufacturing | O.E. specs, double shot peened, double lapped |
| Warranty | Limited lifetime (per G2) |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler YJ with a Dana 30 front axle and a Dana 44 rear axle. Other Wrangler generations such as the TJ, JK and JL are not covered.
Other Wrangler generations such as the TJ, JK and JL are not covered, and a YJ with different axles is not covered either. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Rebuilding a differential around a new ring and pinion is shop work, and the setup procedures for the gears should be followed closely.
- Refill with the correct gear oil and check for leaks after the first miles.
- Verify the kit suits your Dana 30/44 YJ setup before tearing the axle down.
- Gear setup, including pinion depth and backlash, calls for the correct tools and experience, so use a qualified professional.
What’s included
- Front 4.56 ring and pinion set
- Rear 4.56 ring and pinion set
- Matched front minor installation kit
- Matched rear minor installation kit









