Overview
It is a Dana 44 rear axle kit with a 33-spline end and an air-activated selectable locker. It fits the 1987–2001 Jeep Cherokee XJ, the 1997–2006 Jeep Wrangler TJ and the 1987–1995 Jeep Wrangler YJ.
The locker converts the differential from open to fully locked or spool and is operated with a push button. It is air activated, so an air compressor is needed for the locker and is not included. The shafts are forged and heat treated from high tensile alloy steel, with a larger 33-spline diameter for added strength.
Key features
- Air-activated selectable locker
- Converts an open differential to fully locked or spool operation
- Simple push-button control
- 33-spline axle shafts, forged from high tensile alloy steel
- 5-lug, dual drilled 5×4.5/5.5 wheel pattern
Running an air locker
An air-activated locker depends on a steady air supply, so the compressor, tank and air line are part of the drivetrain setup. Mount the compressor where it stays dry and clear of the exhaust, and route the line where rocks and heat cannot reach it. Check every fitting for leaks before the first trail run.
A locked rear behaves differently in turns, so engage it on loose or slick surfaces and release it before tight pavement turns. Listen for uneven engagement, which can point to low air pressure or a worn component. Keep the electrical and air connections sealed against water and mud.
- Check air lines and fittings for leaks
- Keep the compressor intake clear
- Release the locker before pavement turns
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 96-2033-1-33ARB |
| UPC | 70000496121 |
| Axle type | Dana 44 |
| Axle location | Rear |
| Spline count | 33 splines |
| Wheel pattern | 5 lug, dual drilled, 5×4.5/5.5 |
| Locker type | Air-activated selectable |
| Operation | Push button |
| Air compressor | Required, not included |
Vehicle fitment
It fits the 1987–2001 Jeep Cherokee XJ, the 1997–2006 Jeep Wrangler TJ and the 1987–1995 Jeep Wrangler YJ. Confirm fit for your vehicle’s year, model and trim before ordering.
Wrangler JK and LJ models and the Grand Cherokee are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The air locker needs a compressor and an air line to the locker, so plan the air supply before installing the kit. The 33-spline shafts must match your differential, so confirm the spline count on the carrier you are using.
What’s included
A Dana 44 rear axle kit with the air-activated selectable locker.
Not included: Air compressor.







