Overview
The G2 Ford 9 Inch 5.13 Ratio Ring and Pinion, part 2-2011-513, is a rear gear set at 5.13 for the Ford 9 inch axle.
The gears are computer heat treated 8620 steel, double shot peened and double lapped. Minor case clearancing may be needed, and the set works with any ratio carrier.
Key features
- 5.13 gear ratio
- Rear axle position
- Works with all ratio carriers
- Computer heat treated 8620 steel
Case clearancing and fit
Case clearancing removes material from the carrier case where the ring gear rotates, so the new gear set has room to turn. The work is usually done with a grinder and a clearance check using the ring gear. Check the case for casting flash and any cracks before starting, and clean the case thoroughly afterward.
Once clearancing is finished, the carrier can be built. Pinion depth, bearing preload and backlash need to be set, and tooth contact should be checked before the cover goes on. Removing more material than the fit needs is not the goal, so stop once the clearance is adequate.
- Clean metal shavings completely from the case
- Check the carrier bearings and races for wear
- Replace the pinion seal during setup
- Use gear oil with the additive the axle requires
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2011-513 |
| UPC | 631410103762 |
| Make | Ford |
| Axle size | 9 inch |
| Axle location | Rear |
| Gear ratio | 5.13 |
| Warranty | 10 years |
Vehicle fitment
Universal fit is listed, but the set is for a Ford 9 inch rear axle with no model or years given. Confirm the application before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Expect possible minor case clearancing, so check the case before the set is installed. Set preload and tooth contact once the carrier is built.
What’s included
One ring and pinion set.
















