Overview
The G2 Axle and Gear 2-2034-354 is a 3.54 ratio ring and pinion for the Dana 60 axle. The pinion turns 3.54 times for each ring gear revolution, a moderate ratio that keeps engine speed lower at highway speed than numerically higher sets.
The 3.54 set is made for Dana 60 axles in rear and front positions and is designed for oversized tires and high-performance engines. Verify the Dana 60 housing, its location and the carrier on your vehicle before buying.
Key features
- 3.54 gear ratio for the Dana 60 axle
- Fits rear and front axle locations
- Ring gear and pinion supplied as one set
- Designed for oversized tires and high-performance engines.
- Made with current materials and manufacturing methods.
Choosing between ratios
A moderate ratio like 3.54 keeps the engine in a lower rpm band at highway speed, which suits daily driving and longer runs. It gives less low-speed pulling force than steeper sets, so drivers who crawl or tow heavy loads may want to compare options before committing. Tire diameter also changes the effective ratio, so think about the tires you run.
Gears on the Dana 60 are usually replaced as a complete set with the carrier components that support them. When the old gears show chipped teeth, bright wear patches, or a whine that rises with speed, the set is likely due for replacement. Have a gear shop check tooth contact after installation, since the pattern shows whether the setup is correct.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-354 |
| UPC | 631410094114 |
| Axle type | Dana 60 |
| Axle location | Rear or front |
| Gear ratio | 3.54 |
| Axle manufacturer | Dana |
Vehicle fitment
The 3.54 set matches the Dana 60 axle in rear or front positions. Verify the housing type and location on your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth and backlash on a Dana 60 gear set have to be measured, so a gear shop is the usual choice. Expect a break-in period before loaded towing.
What’s included
One 3.54 ring and pinion set for the Dana 60 axle, part number 2-2034-354.
Not included: Carrier bearings and shims are not included with the set. Check them against your Dana 60 carrier before installation.
















