Overview
The G2 Axle and Gear 2-2046-410L is a 4.10 ratio long ring and pinion for the Ford 10.25 inch rear axle. It fits the rear location and works with all ratio carriers.
The gears are built for oversized tires and high performance engines, using computer heat treated 8620 steel with double shot peened and double lapped surfaces. Fitting the Ford 10.5 inch housing requires the 35-2046 Master Kit.
Key features
- Long 4.10 ratio rear ring and pinion
- Ford 10.25 inch rear axle
- Works with all ratio carriers
- Fits Ford 10.5 inch with the 35-2046 Master Kit
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Long gear set fitment
A long pinion version changes where the pinion sits relative to the ring gear, which is why it must match the housing design and the carrier it goes into. Before buying, compare the housing identification and carrier with the gear set so the pinion bearings and shims line up.
Axle shafts, the pinion yoke and the differential side bearings are often replaced alongside a gear change, since they carry the same loads. Inspect them for wear before the gears go in, and replace the pinion seal and crush sleeve during the same job if the setup calls for it.
- Check the axle shafts for play
- Replace the pinion seal during the rebuild
- Use new carrier shims and bearings when setting depth
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2046-410L |
| UPC | 631410094466 |
| Gear ratio | 4.10 |
| Axle location | Rear |
| Axle type | Ford 10.25 inch and Ford 10.5 inch |
| Popular axle manufacturer | Ford |
| Carrier requirement | All ratio carriers |
| Version | Long |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is made for the Ford 10.25 inch rear axle, and for the Ford 10.5 inch when the 35-2046 Master Kit is used. Confirm your vehicle’s year, model and trim before ordering.
Only the Ford 10.25 inch and Ford 10.5 inch is named for this 4.10 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The Ford 10.5 inch use requires the 35-2046 Master Kit, and a driveline shop should set pinion depth, backlash and bearing preload before break-in.
What’s included
A matched long ring and pinion for the Ford 10.25 inch rear axle.
Not included: the 35-2046 Master Kit.
















