Overview
The G2 Axle and Gear 95-2018-002 is a forged 1541H steel rear axle shaft for the GM 12 bolt 8.875 inch axle, made for the 1970–1981 Chevrolet K10 4WD. It has 30 splines and a 6 on 5.5 bolt pattern.
The shaft is marked LH/RH, so one part number serves the driver and passenger sides. It is heat treated to exceed OEM specifications and built to carry more torque than the factory part.
The 95-2018-002 is the four-wheel-drive shaft in the GM 12 bolt range, with the 6 on 5.5 pattern used by K10 trucks. It is forged from 1541H steel and heat treated beyond OEM specifications. It is made for the 1970–1981 Chevrolet K10 4WD.
Key features
- Forged 1541H steel
- 30 splines
- 6 on 5.5 bolt pattern
- LH/RH, either side
- GM 12 bolt 8.875 inch rear axle
- Heat treated beyond OEM specifications.
Matching the shaft to gears
A 12 bolt shaft has to match the spline count of the differential side gears. A shaft with a different spline count will not engage properly, and it can wear the gear end quickly. Count the splines on the old shaft and compare them with the gears before pulling the axle apart. Check the wheel bolt pattern as well, since the hub studs must line up with the wheel.
Some work is best done as a set. Replace the axle seal and bearing when the shaft comes out, because the seal is easy to reach at that point and a leaking seal can contaminate the gears. Check the differential oil level and refill with clean gear oil. After the first few trail runs, check the retainer bolts and wheel studs for tightness, since new hardware can settle as it seats.
- Count splines before removal
- Check the wheel bolt pattern
- Inspect seal and bearing at the same time
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2018-002 |
| UPC | 631410106091 |
| Product type | Replacement axle shaft |
| Axle type | GM 12 Bolt 8.875 inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 30 |
| Material | Forged 1541H steel |
| Bolt pattern | 6 on 5.5 |
| Stated application | 70-81 K10 4WD |
Vehicle fitment
No vehicle list comes with the 95-2018-002. G2’s title and description state 70-81 K10 4WD, which is the 1970–1981 Chevrolet K10.
Fitment covers the K10 only, with no full model list, so check other trucks against their own axle, spline count and bolt pattern. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Check your wheels against the 6 on 5.5 bolt pattern.
- The 30-spline shaft must match the gears in a 12 bolt differential.
What’s included
One rear axle shaft that fits either side (95-2018-002).
Not included: wheel studs.







