Overview
The G2 Axle and Gear 95-2013-010 is a rear driver-side replacement axle shaft for the Ford 8.8 inch axle in the Ford Ranger, made for the 1993–1997 model years. It has 28 splines.
G2 Axle and Gear describes its replacement shafts as forged from high grade alloy steel and heat treated to exceed OEM specifications. The point, in the company’s words, is to handle high-torque use and fix weak points found on factory shafts.
The 95-2013-010 serves the Ford Ranger with the 8.8 inch rear axle and uses a finer 28-spline count than many Ford shafts of this size. G2 Axle and Gear describes its replacement shafts as forged and heat treated to exceed OEM specifications, built to cure common faults in factory shafts. Compare the spline count, the side and the model year before installing, and note the 1992 versus 1993 difference between G2’s text and its vehicle list.
Key features
- Driver-side rear shaft for the Ford 8.8 inch axle
- 28-spline shaft
- Made for the Ford Ranger
- Forged and heat treated alloy steel
- Wheel studs not included
Pairing the shaft with the axle
A rear axle shaft carries torque from the differential to the wheel hub, so it is loaded every time the truck accelerates, brakes or climbs. Wear usually shows at the splines, the bearing and the seal near the axle tube. A worn spline can slip under load, and a damaged bearing can make a grinding or humming noise that changes with speed. Inspect both ends of the shaft before fitting a new one.
Matching the shaft to the axle is the main step. Count the splines on the shaft and on the differential side gear, and confirm the shaft goes on the correct side. Wheel studs must be installed separately, so have them ready before starting. After the first short drive, check the axle seal for leaks and listen for new noises from the hub.
- Check spline ends for twisting or wear
- Inspect the bearing and axle seal on that side
- Keep the spline count matched to the gears
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2013-010 |
| UPC | 631410105797 |
| Product type | Replacement axle shaft |
| Axle type | Ford 8.8 inch |
| Axle location | Rear |
| Shaft position | Driver Side |
| Spline count | 28 |
| Wheel studs | Not included |
| Stated application | 1992-1997 Ford Ranger driver side |
Vehicle fitment
G2’s vehicle list for the 95-2013-010 shows the 1993–1997 Ford Ranger.
G2’s short description says 1992–1997, but the vehicle list begins at 1993, so a 1992 Ranger should be confirmed with G2. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- With 28 splines, the shaft must be paired with differential gears that also have 28 splines.
- Wheel studs are absent, so supply studs before the shaft goes into service.
What’s included
One driver-side rear axle shaft (95-2013-010).
Not included: wheel studs for the 95-2013-010.







