Overview
The G2 Axle and Gear 95-2012-003 is a Ford 9.75 inch rear passenger side axle shaft with 34 splines and a 5 on 135mm bolt pattern for the 1999–2002 Ford F150, Navigator and Expedition. G2’s notes pair this shaft with 14mm press fit wheel studs, and the studs are not included. The company says its shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications.
It fits 1999 Ford F-150, Navigator and Expedition models. Confirm fit for your vehicle’s year, model and trim before ordering, especially on 2000 through 2002 trucks. This passenger side shaft uses 14mm press fit studs, unlike the studs on the earlier 95-2012-001, so stud size is one of the first things to check. It has 34 splines and a 5 on 135mm bolt pattern. Expedition owners can use the same part number as F-150 owners, and a buyer replacing both rear shafts will need the driver side partner, part number 95-2012-004.
Key features
- Passenger side rear axle shaft for the Ford 9.75 inch axle
- 34 splines
- 5 on 135mm bolt pattern
- 14mm press fit wheel studs
- Forged from high grade alloy steel.
- Heat treated to exceed OEM specifications.
Before you install
Axle shafts on a 9.75 inch rear carry drive torque from the differential to the wheel hub, so the spline count, bolt pattern and stud type all have to match the housing and the hub. Many shops replace both rear shafts at the same time, because a worn partner shaft can wear the new one through uneven load and play. Before pulling the old shaft, check the splines on the axle end and the side gear in the differential. Count the teeth and compare them with the new part so you are not surprised halfway through the job.
Press fit studs are pressed into the hub flange, and the old ones usually need to be driven out or pressed out with the shaft removed. Clean the flange bore, and use anti-seize only where your hub’s service guidance permits it. Re-check the axle nut or retainer and the wheel torque after the first few drives. A shaft that clicks, vibrates or shows grease at the hub is worn or loose and should be inspected before further use.
- Count the splines on the axle end and the side gear before pulling the old shaft
- Inspect the flange for cracks or elongated stud holes
- Replace both rear shafts together when one has failed
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2012-003 |
| UPC | 631410105896 |
| Axle manufacturer | Ford |
| Shaft location | Passenger Side |
| Axle position | Rear |
| Axle type | Ford 9.75 Inches |
| Position | Rear |
| Spline count | 34 Splines |
| Bolt pattern | 5 on 135mm |
| Wheel stud size | 14mm press fit |
| Material | High grade alloy steel, forged |
| Applications noted | 1999-2002 F150/Navigator/Expedition |
Vehicle fitment
It fits these models: 1997–1999 Ford Expedition (Eddie Bauer, XLT), 1997–1999 Ford F-150 (Base, Lariat, XL, XLT) and 1998–1999 Lincoln Navigator (Base).
- 1997–1999 Ford Expedition (Eddie Bauer, XLT)
- 1997–1999 Ford F-150 (Base, Lariat, XL, XLT)
- 1998–1999 Lincoln Navigator (Base)
Only the years shown above apply to this shaft, so verify your model year. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear axle shaft.
Not included: wheel studs.







