Overview
The Fabtech K2114 is a 6-inch basic lift with performance shocks for the 2009–2013 Ford F-150. It uses a spacer that sits on the factory coilover shock at the front, with Fabtech’s arched lower control arm crossmembers, and blocks with a U-bolt kit at the rear.
The crossmembers are 1/4-inch thick steel with an integrated differential skid plate. Adjustable eccentric cams are built into the crossmembers to set front alignment and help hold alignment under off-road use. The steering knuckles are American made ductile iron, and the kit allows use of 18-inch or 20-inch diameter wheels. The fit is for the SuperCrew with the 5.4L engine only.
Key features
- 6-inch lift, range 5 to 6.99 inches
- Spacer on the factory coilover shock
- Arched 1/4-inch thick steel lower control arm crossmembers
- Integrated differential skid plate
- Adjustable eccentric alignment cams
- Ductile iron steering knuckles
Alignment after a basic lift
A basic lift changes the front geometry, so alignment is the first thing to plan around. Eccentric cams allow camber and caster to be set during the install, but the front still needs a proper alignment check on the truck once the parts are in place. Tire wear often shows an alignment problem early, so watch the edges of the front tires after the first few drives.
Ball joints, tie rods and the steering knuckles all carry more load once the front is raised. Ductile iron knuckles are a sturdy base, but the wear points still need periodic checks, especially on trails. Look for play in the steering and any clunk at the knuckle when the wheel is turned.
Off road, the crossmember and skid plate protect the front differential, and the impact struts help control the axle when the truck lands hard. Rocks and stumps still hit low parts, so inspect the crossmember welds, the skid plate bolts and the sway bar brackets after rough use. Tighten any loose hardware and keep the cams set to the alignment chosen at install.
- Re-check front alignment after the first few drives
- Inspect crossmember welds and skid plate bolts after trail use
- Look for play in tie rod ends and ball joints
- Check spring spacers and shock mounts for wear
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K2114 |
| UPC | 70000500847 |
| Lift height | 6 inches (range 5 to 6.99 inches) |
| Suspension type | Knuckle |
| Front lift | Crossmember, steering knuckles and factory coilover spacers |
| Rear lift method | Lift blocks and U-bolts |
| Tire and wheel fit | 35/13.50R20 on 20×9 with 5-inch backspace |
| Engine | SuperCrew with 5.4L only |
| Shocks | Performance shocks included |
Vehicle fitment
It fits the 2009–2013 Ford F-150, including the FX4, King Ranch, Lariat, Limited, Platinum, STX, XL and XLT models.
It fits the SuperCrew body with the 5.4L engine only, so other F-150 cabs and engines are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The eccentric cams make alignment adjustable at the front, so the front end should be aligned after the kit is installed. The kit includes sway bar brackets, impact struts and a differential skid plate with the crossmember.
What’s included
Arched lower control arm crossmembers with the integrated skid plate, steering knuckles, the spacers for the factory coilover shocks, sway bar brackets, impact struts, alignment eccentric cams, blocks and a U-bolt kit, and performance shocks.









