Overview
The Fabtech FTS24224 is a front long arm kit for the 2021–2026 Jeep Wrangler (JL), covering the 2-door Rubicon, Sport and Sport S and the Unlimited 4-door Rubicon, Sahara, Sport and Sport S. It belongs to Fabtech’s JL Crawler long arm line, which uses 5 Ton link arms mounted to the frame in place of the factory control arms.
The frame-side mounting points set the geometry and ground clearance of the link arms, and the geometry was chosen for these arms. A full-width front crossmember spans frame rail to frame rail, which adds strength to the JL frame for hard off-road use. The lower link arms are 2-inch OD tubing with a .313 thick wall. The upper and lower arms use 5 Ton joints, which carry a lifetime wear guarantee. The arms run smoothly and quietly on the street.
Key features
- Lower link arms of 2-inch OD, .313 thick wall tubing
- Full-width front crossmember that spans frame rail to frame rail
- Upper and lower link arms with Fabtech 5 Ton joints
- Rear links attach to new frame mounts for ground clearance and approach angle
- Runs smoothly and quietly on the street
Long arm geometry in daily driving
Long arms control the axle with a fixed link geometry, which keeps the wheel path predictable as the suspension moves. On the street, the effect shows up as a steady ride and less wander over expansion joints. Steering feel can change slightly with new geometry, so the front alignment should be checked and set after installation.
Joints and bushings are the main wear points in a long arm front end. Look for play at the joints and cracks in any rubber bushings during routine checks, especially after rocky trail work. Front tire wear that appears on one edge can point to alignment drift or a loose joint, and it is worth catching early.
- Check joints for play after rough trail use
- Inspect bushings for cracks or separation
- Watch for uneven front tire wear
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS24224 |
| Type | Front long arm kit |
| Lower link arm tubing | 2-inch OD, .313 thick wall |
| Joints | 5 Ton |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2021–2026 Jeep Wrangler JL 2-door in the Rubicon, Sport and Sport S trims, and the Unlimited 4-door in the Rubicon, Sahara, Sport and Sport S trims.
The list does not cover the JL from 2018–2020 or the JK Wrangler. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Long arm kits change the front suspension geometry, so an alignment is needed after installation. Check the driveline angles too, because the axle position changes with the new arms.
What’s included
Front link arms, the full-width crossmember and the 5 Ton joints. Check the package contents against your installation before starting.










