Overview
The Fabtech FTS26039 is a 4 inch upper control arm lift kit with uniball joints for the front upper position of the 2007-2013 Toyota Tundra. It includes heavy duty control arms and bushings. It fits the Base, Limited, Platinum and SR5 trims of the Tundra.
The kit is a front upper control arm system with heavy duty arms and bushings, sized for a 4 inch lift. Confirm the finished height for your truck before ordering.
Key features
- 4 inch upper control arm lift
- Uniball joints
- Front upper position
- Heavy duty control arms
- Bushings included
- Direct-fit design for the listed Tundra trims
Front suspension geometry
Upper control arms set the front geometry, so a lift at this position changes caster and camber as well as ride height. An alignment check after the install helps keep tire wear even and steering predictable.
Uniball joints allow more articulation than a standard bushing, which suits off-road use but puts more stress on the joint boots and grease points. Inspect the joints for play and boot tears at regular service intervals.
Brake lines, ABS wiring and the front driveline should be checked once the arms are in, since the geometry changes where they sit. Upper arms are often replaced in pairs so both sides wear and set up the same way.
- Re-check alignment after the first few drives
- Look for play in uniball joints during service
- Inspect brake hoses for stretch at full travel
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS26039 |
| UPC | 674866037571 |
| Lift | 4 inch upper control arm lift |
| Position | Front upper |
| Joints | Uniball |
| Fitment type | Direct fit |
Vehicle fitment
The kit fits the 2007-2013 Toyota Tundra in the Base, Limited, Platinum and SR5 trims.
Other Tundra years and trims, and other Toyota trucks, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Upper control arms change the camber and caster settings, so check the front alignment after installation. Confirm whether the front and rear heights need additional parts for your setup.
What’s included
The kit includes front upper control arms with uniball joints, heavy duty control arms and bushings.









