Overview
The Fabtech FTS21127 is a front upper control arm lift kit with uniball joints, sold as a 0 to 6 inch lift. It replaces the front upper control arms with heavy duty arms and bushings. It fits the 2011-2018 Chevrolet Silverado 2500 HD and 3500 HD and the 2011-2018 GMC Sierra 2500 HD and 3500 HD, in the trims named in the fitment entry.
The kit is a direct-fit control arm system for the front upper position and comes with heavy duty control arms and bushings. Check the lift height and any other parts needed for your setup before installing.
Key features
- Front upper position
- Heavy duty control arms
- Bushings included
- Uniball joints in the upper arms
- Lift range of 0 to 6 inch
- Direct-fit design for the listed HD trucks
Setting alignment and clearance
Upper control arms set the caster and camber, so swapping them shifts the alignment even when the lift is modest. A shop with a four-wheel alignment rack can set the front geometry once the arms are installed and the ride height has settled.
Uniball joints are used where a bushing would normally sit, which gives more articulation but also needs regular inspection and greasing depending on the design. Check the joints for play at each service and watch for uneven tire wear.
Brake hoses, ABS lines and the front driveline should be checked once the arms are in, since the geometry changes where those parts sit. Tire size and wheel offset also affect clearance, so decide on those before the install.
- Re-check alignment after the first few drives
- Inspect uniball joints for play and binding
- Check brake lines for stretch at full articulation
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS21127 |
| UPC | 674866037113 |
| Lift range | 0 to 6 inch |
| Position | Front upper |
| Components | Heavy duty control arms and bushings |
| Fitment type | Direct fit |
Vehicle fitment
The kit fits the 2011-2018 Chevrolet Silverado 2500 HD (High Country, LT, LTZ and WT) and 3500 HD (High Country, LT, LTZ and WT), and the 2011-2018 GMC Sierra 2500 HD (Base, Denali, SLE, SLT and WT) and 3500 HD (Base, Denali, SLE, SLT and WT).
The 1500 Silverado and Sierra are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing the upper control arms changes the caster and camber, so the front alignment should be set after the install. Check the brake lines and the front driveline angles once the lift height is set.
What’s included
The kit includes front upper control arms with uniball joints, heavy duty control arms and bushings. Check the package contents against your installation before starting.









