Overview
The Fabtech K2132 is a 6-inch 4-link lift with performance shocks for Ford Super Duty trucks built without dual rear wheels. The 4-link is designed for articulation and wheel travel, and the kit’s range is 5 to 6.99 inches.
The links are 2-inch OD heavy wall tubing with race style 1-inch Uniballs. Thick 1/4-inch steel brackets hold the links to the frame and install without cutting or welding. The front uses Fabtech coil springs, and the rear uses lift blocks with a U-bolt kit. Sway bar drops, a trac bar relocation bracket and a pitman arm handle steering correction.
Key features
- 6-inch lift, range 5 to 6.99 inches
- 2-inch OD heavy wall links
- Race style 1-inch Uniballs
- 1/4-inch thick steel frame brackets
- Fabtech coil springs at the front
- Performance shocks included
Choosing a 4-link setup
A 4-link controls axle location with two upper and two lower arms, so the axle moves up and down without shifting side to side. Wheel travel and articulation depend on the arm angles, bushing condition and how cleanly the frame brackets sit. Before buying, consider how the truck is used. Daily driving on pavement puts different loads on the joints than rock crawling does, and the choice of shock and spring rate affects how the truck feels at highway speed.
After installation, inspect the link ends, Uniballs and frame brackets at the first service and again after the first several trail runs. Re-torque all fasteners after the first few drives. Check tire clearance at full steering lock and full compression, and set alignment after the lift because caster and toe change once the arms are fitted.
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K2132 |
| UPC | 70000583670 |
| Lift height | 6 inches (range 5 to 6.99 inches) |
| Suspension type | 4-link |
| Front lift | Upper and lower link arms with coil springs |
| Rear lift method | Lift blocks and U-bolt kit |
| Steering correction | Pitman arm |
| Tire and wheel fit | 325/65R18 on 18×9.5 with 4 3/4-inch backspacing |
| Applies to | Non-dually models only |
| Shocks | Included |
Vehicle fitment
It fits non-dually Ford Super Duty trucks. Confirm fit for your vehicle’s year, model and trim before ordering.
Dually models are not covered by this kit. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
A front driveline modification may be needed to clear the exhaust on a gas engine. Check that clearance before driving the truck after installation.
What’s included
Four-link upper and lower link arms, Fabtech coil springs for the front, a lift block and U-bolt kit for the rear, sway bar drops, a trac bar relocation bracket, a pitman arm and performance shocks.









