Overview
The Dana Spicer D/S5-811X is a universal joint for the rear driveshaft at the rear axle. It is in the 7290 series, with an ISR span of 2.625 and an ISR cap diameter of 1.125, and it is a direct fit.
Confirm the series, ISR span and ISR cap diameter against the joint being replaced before ordering.
Replacing a driveshaft U-joint
A driveshaft U-joint lets the driveshaft change angle as the axle moves over bumps. Each joint has bearing cups held in place by caps, and wear inside those cups shows up as vibration or a clunk when the drivetrain loads or unloads. Replacing the joint in a pair or a set is a common practice when one shows wear, since the other is usually close behind.
Check the yoke and flange alignment before removing the old joint, and mark the driveshaft position so it returns the same way. Clean the yoke ears, use new retainers, and grease the new joint until a little grease shows at the seals. Balance and runout matter as much as the joint itself, so have the driveshaft inspected if it was dropped or bent.
- Vibration that rises with speed
- Clunking when shifting between drive and coast
- Grease leaking from the bearing caps
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | D/S5-811X |
| Series | 7290 |
| ISR span | 2.625 |
| ISR cap diameter | 1.125 |
| Position | Rear driveshaft at rear axle |
| Fitment type | Direct fit |
Vehicle fitment
This joint fits a broad run of Dodge vehicles from the early 1970s through the late 1990s. The Dodge coverage includes B-series vans (B100 through B350), D-series and W-series pickups, the Dakota, the Durango, the Ram 1500, 2500 and 3500, and the Ramcharger. Jeep coverage includes the Cherokee (XJ) from 1994 to 1999 and the Grand Cherokee (ZJ) from 1994 to 1998. The Plymouth Trailduster fits 1974 to 1981.
The list spans many generations and body styles, so match the make, model, year and driveshaft position of your vehicle before ordering. Confirm your vehicle’s year, model and trim before ordering.









