Overview
The Dana Spicer Universal Joint Strap Kit for the 1480/1550 Series, part number D/S3-70-38X, holds a driveshaft’s U-joint in place with stamped steel straps and grade 8 retaining bolts.
Dana Spicer says its kits are made for most common driveshaft U-joint sizes, so match the kit’s series to your joint before fitting.
Key features
- Stamped steel straps that retain the driveshaft joint
- Supplied with grade 8 retaining bolts
- It is made for the 1480/1550 Series.
- Dana Spicer says kits cover most common driveshaft U-joint sizes
Keeping the driveshaft joint secure
A strap kit holds the driveshaft U-joint in its bearing caps so the joint cannot walk out of position. Stamped steel straps spread the load across the retention points, and grade 8 bolts give the clamp its hold. Keeping those parts tight matters because a loose joint can knock, vibrate and wear the surrounding parts quickly.
Before installing, clean the joint and bearing cap surfaces and confirm the series matches the joint in use. Check the straps for bending or cracks, and replace any bolt that is stretched or damaged. Once the driveline is back in, road test at low speed and listen for clunks or vibration that could signal a loose joint.
- Inspect U-joint caps for play before fitting
- Use new fasteners if the old bolts are stretched
- Recheck retention after the first few drives
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | D/S3-70-38X |
| Series | 1480/1550 |
| Strap material | Stamped steel |
| Retaining bolts | Grade 8 |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering. Match the 1480/1550 Series to your driveshaft joint before fitting.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit comes with stamped steel straps and grade 8 retaining bolts.









