Overview
The Dana Spicer Dana 60 spindle stud, part number 37879, is a replacement spindle stud for Dana 60 axle knuckles. Dana Spicer says these hard-to-find studs are designed to fit the application without damaging the knuckle.
Dana Spicer advises against welding ordinary bolts to the knuckle, and these studs are offered as the proper replacement for that repair.
Repairing a cracked knuckle
The spindle on a Dana 60 knuckle carries the wheel bearings and hub, and the studs hold hub and brake components in place. Over time, stripped or broken studs are often found after a wheel has been removed repeatedly or after the knuckle has been overloaded. Removing a damaged stud requires care, because heat and force can crack the knuckle around the stud hole.
Before fitting a new stud, clean the hole and check the threads for corrosion. Look for cracks in the knuckle, signs of previous welding and worn bearing surfaces. If the hole is oversized or the metal is cracked, a new stud alone will not restore strength, and the knuckle may need replacing. Tighten the nuts to the axle specification and recheck them after the first few miles of driving.
Keep a record of any knuckle repair, including the stud size and the date, so future service is simpler. Inspect the knuckle again whenever the hub is removed for bearing work.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 37879 |
| UPC | 23913139421 |
| Application | Dana 60 spindle studs |
Vehicle fitment
Dana 60 is an axle name rather than a vehicle, so match the stud to your knuckle and hub before installing it.
What’s included
Confirm the number of studs you need for your repair before ordering.









