Overview
The Dana Spicer 37759-1 is a spindle stud for Dana 44 hubs and spindles. It is a replacement for improvised bolts welded to the knuckle and is designed to fit without damaging the knuckle. It is universal fit, but it belongs to the Dana 44 hub and spindle category, so check the fitment section below before ordering.
Key features
- It is designed to fit the spindle application without damaging the knuckle.
- Presented as an alternative to welding bolts onto the knuckle.
- Dana Spicer brand, part number 37759-1.
- UPC 23913139407.
- It is universal fit.
Hub and spindle stud basics
Spindle studs carry the load of the hub and bearing assembly, so their threads need to be clean and undamaged before the hub goes back on. Welded bolts on the knuckle can weaken the knuckle metal, which is one reason a proper stud is preferred. A stud that is pressed or threaded into the knuckle should sit square without binding. Compare the new stud length with the old one before fitting, so the hub seats fully.
Check the stud threads and the knuckle bore for corrosion and galling when the hub is off. Use the torque and lubricant your axle service calls for, and recheck the hub nut after the first few drives. If the knuckle shows cracks near the stud, address that before reinstalling.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 37759-1 |
| UPC | 23913139407 |
| Fitment listed | Universal Fit |
Vehicle fitment
No vehicle-specific fit is given for this stud. It is universal fit, but it is a Dana 44 hub and spindle part, so confirm that it matches your axle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Confirm the quantity and hardware you need against your installation before starting.









