Overview
The Dana Spicer wheel seal (part 36366) is made for GM “big bearing” front spindles. It sits on the back side of the front wheel hub of GM Dana 44 and 10-bolt front axles.
The inner bearing is an LM104949. Dana Spicer says one seal is required per side.
Before you install a wheel seal
A wheel seal sits between the hub and the spindle. It keeps lubricant in the bearing area while keeping water and grit out. On a front hub it has to hold through every water crossing and every highway mile, so a seal that starts to weep is usually an early warning rather than a cosmetic issue.
Seals rarely fail on their own. When the seal is replaced, inspect the bearing, the race and the spindle surface where the lip rides. A scored spindle or a loose bearing will wear out a new seal quickly. Clean the hub cavity, pack the bearing with fresh grease, and seat the seal square so the lip is not pinched. Check for leaks after the first few drives.
- Look for grease on the brake rotor or inside the wheel
- Check the bearing for play before fitting
- Replace the bearing race if it is pitted
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 36366 |
| UPC | 23913139148 |
| Application | GM “big bearing” front spindles |
| Axles | GM Dana 44 and 10-bolt front |
| Location | Back side of the front wheel hub |
| Inner bearing | LM104949 |
| Quantity | One per side |
Vehicle fitment
This seal is identified by axle and spindle type rather than by vehicle year or model. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
The package is a single wheel seal, and one is needed for each side. Check the package contents against your installation before starting, including the inner bearing LM104949.









