Overview
The Dana Spicer spindle nut kit, part number 28068X, is a set of spindle nuts for one side of a front axle. It covers Dana 30 Standard, Dana 44 and GM 10 bolt 8.5 inch axle types.
The kit has an outer nut without a pin, a locking ring and an inner nut with a pin. It services one side only, so use one kit per side.
Key features
- Outer nut without pin
- Locking ring included
- Inner nut with pin
- Services one side only
- It is designed for front Dana 30 Standard, Dana 44 and GM 10 bolt 8.5 inch axles.
Spindle nuts and preload
Spindle nuts set the bearing preload on the spindle, so the outer nut, locking ring and inner nut must be tightened in the order the service procedure calls for. A nut that is too tight binds the bearings and heats the hub, while one that is too loose lets the wheel rock and wear the bearing races. The locking ring keeps the outer nut from backing off once the preload is set.
Before installing, clean the spindle threads and check them for damage, because a nicked thread can give a false torque reading. Replace the nut set if the threads are stretched or the locking ring is bent. Work on one side at a time, and keep track of which kit goes where.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 28068X |
| UPC | 23913137434 |
| Kit contents | Outer nut without pin, locking ring, inner nut with pin |
| Axle location | Front |
| Axle types | Dana 30 Standard, Dana 44, GM 10 Bolt 8.5 Inches |
| Coverage | One side only |
| Universal fit by axle type | Universal fit |
Vehicle fitment
Fit is by axle type, covering Dana 30 Standard, Dana 44 and GM 10 bolt 8.5 inch front axles as universal fit. Check the spindle nut type on your axle before ordering.
Dana 30 Reverse and Dana 30 TJ types are not covered by this kit. Check your year, model and trim against the vehicle before ordering.
Installation notes
Because the kit services one side only, a separate kit is needed for each spindle you rebuild. Check the nut type on your axle before removing the existing nut.
What’s included
The kit includes an outer nut without pin, a locking ring and an inner nut with pin. Not included: Check the spindle, bearings and seals against your rebuild before starting, since they are not part of this kit.









