Overview
The TeraFlex 3034411 is a front 8-lug locking hub conversion kit that turns a JK Wrangler’s Dana 30 or Dana 44 front axle into a full float design. The kit is listed to fit 2007 to 2016 Jeep Wrangler JK models, two- and four-door, and it includes the TeraFlex performance big rotor kit.
A full float conversion moves the wheel bearings farther apart within the hub, which TeraFlex says greatly reduces the load on each bearing. The kit uses a forged 4140 chromoly spindle that accepts standard bearings and seals, along with forged 4340 chromoly 35-spline stub shafts that are larger than stock.
The conversion uses an 8 on 6.5 inch wheel bolt pattern, which does not match the factory pattern, and it carries one-ton Dana 60 application components throughout. The hub design seals the OE wheel speed sensors from mud, rock and other contaminants, so the ABS and stability systems keep receiving clear signals. For flat towing, the hubs can be set in the unlocked position during transport.
Key features
- Forged 4340 chromoly 35-spline stub shafts, larger than stock
- Forged 4140 chromoly spindle that accepts standard bearings and seals
- 8 on 6.5 inch wheel bolt pattern, one-ton Dana 60 components throughout
- Wheel speed sensors sealed from mud, rock and other contaminants
- Hubs can be set unlocked for flat towing
- Includes the TeraFlex performance big rotor kit
Full float fit and wheels
A full float hub moves the load away from the axle shaft and onto the bearings in the hub, which changes how the front axle handles heavy tires and rough terrain. The shaft carries torque but does not bear the vehicle weight, so the axle is less likely to bend under load. The design suits drivers who run larger tires or a lift and want the front axle to hold up under that extra stress.
Plan the wheel side of the job before buying. A different bolt pattern means wheels must match the new pattern before installation, and wheel offset affects clearance at the steering and suspension. Check front driveline angles after any lift, since the stub shaft and U-joint geometry change with ride height. Replace gaskets and seals whenever the hub is opened, and inspect the wheel bearings during the install.
- Confirm wheel bolt pattern and offset before buying
- Check driveline angles after any lift
- Replace hub gaskets and seals when the hub is opened
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 3034411 |
| UPC | 843885035244 |
| Position | Front |
| Application | JK Dana 30 and Dana 44 front axles |
| Stub shafts | Forged 4340 chromoly, 35 spline, larger than stock |
| Spindle | Forged 4140 chromoly |
| Wheel bolt pattern | 8 on 6.5 inches (does not retain factory pattern) |
| Axle components | One-ton Dana 60 application throughout |
| Big rotor kit | TeraFlex performance big rotor kit included |
| Fitment | Direct fit and universal fit |
Vehicle fitment
This kit is for the 2007 to 2016 Jeep Wrangler (JK), two- and four-door models.
The kit may not work with all wheels, and 2007 to 2012 Dana 30 axles need new inner shafts with the larger U-joint end forgings. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit replaces the front hub and axle shaft components, so plan for the new inner shafts on 2007 to 2012 Dana 30 axles. All 2013 and later JK Dana 30 and Dana 44 axles use the same U-joint. Because the full float kit may not work with every wheel, check wheel fitment before installation.
What’s included
The full float locking hub conversion kit with stub shafts, spindle and the TeraFlex performance big rotor kit.









