Overview
The Dana Spicer 660182-11 is a driver side front inner axle shaft for Dana 60 axles, with 35 splines. It is an O.E. replacement design, matching the factory layout the axle was built with.
Inner shafts run from the differential toward the driver side front hub. No vehicle years or models are named, so compare the side and spline count with the shaft you are replacing.
Key features
- Driver side inner position
- 35 spline count
- O.E. replacement design
- Dana 60 front axle type
Driver side axle checks
The driver side inner shaft runs from the differential toward the front hub, and the axle seal at the differential end is often disturbed when the shaft comes out. Before fitting a new shaft, look at the seal lip, the bearing area and the axle housing for old gear oil or fresh leaks. Fixing a leak now is much easier than doing it after the shaft is back in place.
Hub condition deserves a look as well. Check the hub bearing and seal for play and roughness, and make sure the mating faces are free of rust and debris. Use fresh lubricant to the correct level once the work is finished, and recheck for leaks after the first several miles of driving so any issue is caught early.
- Check the differential end seal for leaks
- Inspect the hub bearing for play
- Clean mating faces before assembly
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 660182-11 |
| Axle type | Dana 60 |
| Axle location | Front |
| Shaft location | Driver side inner |
| Axle spline | 35 splines |
| Popular axle manufacturer | Dana |
Vehicle fitment
Confirm the vehicle match by checking the Dana 60 front axle on your truck against this shaft’s side and spline count.
Side, axle type and spline count are not a full vehicle match. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The item is the driver side inner shaft only. Confirm the hardware, seals and bearings you need before starting the swap.






