Overview
The G2 Dana 44 JK Rubicon replacement rear axle shaft, part 95-2052-2-321, is the driver side rear shaft for the 2007–2018 Jeep Wrangler JK Rubicon.
It is forged from high-strength alloy steel and heat treated to exceed OEM specifications, for high-torque use and larger tires. It has 32 splines, a 31.18 inch overall length, a 5 on 5 inch bolt circle and a 2.828 inch pilot. Wheel studs are not included.
Key features
- Driver side rear shaft for the Wrangler JK Rubicon
- 32 splines
- 31.18 inch overall length
- 5 on 5 inch bolt circle with a 2.828 inch pilot
- Forged alloy steel, heat treated to exceed OEM specifications
- It is built to handle larger tires and high-torque use.
Rear axle shaft upkeep
A rear axle shaft carries drive torque from the differential to the wheel hub, and it takes the load of tire size changes, hard acceleration and trail obstacles. The shaft works with the axle bearing and seal, so these parts should be checked together. A worn bearing lets the shaft shift and can make a clunk or a whine at speed. Grease on the inside of the wheel points to a seal that needs attention.
When installing a new shaft, match the wheel studs to the thread size and confirm the bolt circle before tightening the wheel. Use a torque wrench and follow a star pattern on the lug nuts, then recheck them after the first few drives on rough terrain. Keep the brake and bearing area clean, since grit trapped at the seal shortens the life of the new shaft.
- Check the axle bearing for play
- Inspect the inner seal for grease leaks
- Confirm stud thread before installing wheels
- Recheck lug nuts after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2052-2-321 |
| UPC | 631410106473 |
| Axle type | Dana 44 JK |
| Position | Rear |
| Side | Driver side |
| Spline count | 32 splines |
| Overall length | 31.18 inches |
| Bolt circle | 5 on 5 inch |
| Pilot | 2.828 inch |
| Wheel stud thread | 1/2 inch |
| Wheel studs | Not included |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler JK, matching the Dana 44 rear axle used on those trims.
Other Wrangler generations, such as the TJ and JL, are not covered by this statement. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match your wheel studs to the 1/2 inch thread before installing the shaft. Wheel studs are not included.
What’s included
One driver side rear axle shaft.
Not included: wheel studs.






