Overview
It is a Dana 44 rear axle kit with 33 splines and a 5-lug dual drilled 5×4.5/5.5 wheel pattern, built for a Dana 44 Rubicon rear. It fits the 1991–1993 Jeep Cherokee XJ, the 1997–2006 Jeep Wrangler TJ and the 1991–1995 Jeep Wrangler YJ.
It is an upgrade over the factory shafts. Its forged and heat-treated high tensile alloy steel shafts handle higher torque, and the larger 33-spline diameter adds strength over the stock diameter. The kit comes with wheel bearings, seals and screw-in wheel studs. The differential is not included, so a 33-spline aftermarket carrier is needed.
Key features
- 33-spline Dana 44 Rubicon rear axle kit
- Forged and heat-treated high tensile alloy steel shafts
- Wheel bearings and seals included
- Screw-in wheel studs included
- 5-lug, dual drilled 5×4.5/5.5 wheel pattern
Hub and seal setup
The kit includes wheel bearings, seals and screw-in wheel studs, so the hub assembly is part of the job. Check the bearing seat and the housing bore before seating the new components, and clean out any old grease. Apply grease to the bearing and seal lips as the assembly goes together.
Screw-in studs are set into the hub with the bearing assembly. Confirm the studs are seated fully and that the wheel hub sits flat against the flange before fitting the tire. Recheck the axle nuts and wheel lug torque after the first few drives, and inspect the seals for leaks.
- Clean the housing bore before install
- Seat the screw-in studs fully
- Check seals for leaks after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 96-2045-2-33 |
| UPC | 631410114133 |
| Axle type | Dana 44 Rubicon |
| Axle location | Rear |
| Position | Rear left |
| Spline count | 33 splines |
| Wheel pattern | 5 lug, dual drilled, 5×4.5/5.5 |
| Differential | Not included |
Vehicle fitment
It fits the 1991–1993 Jeep Cherokee XJ, the 1997–2006 Jeep Wrangler TJ and the 1991–1995 Jeep Wrangler YJ Rubicon. Confirm fit for your vehicle’s year, model and trim before ordering.
Other Cherokee and Wrangler years, the JK and LJ, and the Grand Cherokee are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes wheel bearings and seals, so the hub and bearing setup is covered by the kit. The 33-spline shafts require a 33-spline aftermarket differential, which is not included.
What’s included
Dana 44 rear axle kit with 33-spline shafts, wheel bearings, seals and screw-in wheel studs.
Not included: Differential.






