Overview
The Curt Manufacturing 56281 is a vehicle to trailer connector with harness and 4-way flat output. It fits select INFINITI QX60 and Nissan Pathfinder model years. It connects the vehicle’s tail and signal circuits to a trailer’s 4-way flat plug.
Signal circuits are rated at 7.5 amps per side, and the tail and running circuits are rated at 7.5 amps total. The vehicles it fits appear in the fitment section below.
Key features
- 4-way flat output for trailer lights
- Signal circuits rated at 7.5 amps per side
- Tail and running circuits rated at 7.5 amps total
- Listed install time of 30 minutes
Trailer lighting loads
Circuit ratings set a practical limit on how much trailer lighting a tow vehicle can feed through a connector. When the total draw climbs past that limit, the wiring can run warm, fuses can blow and lights can flicker. Adding a second light bar or auxiliary lamp to a trailer is a common way to exceed a circuit’s rating without noticing it.
LED trailer lighting draws far less current than older incandescent bulbs, which makes it a good match for limited circuits. Before connecting a trailer, add up the lights it carries and compare the total with the circuit ratings. Keep the wiring routed clear of hot exhaust parts and use protected connections at any splices outside the vehicle.
- Total the current draw of all trailer lights
- Consider LED lamps for lower draw
- Check fuses after the first trip
- Route wiring away from exhaust heat
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT56281 |
| Output | 4-way flat |
| Signal circuit rating | 7.5 amps per side |
| Tail/running circuit rating | 7.5 amps total |
| Install time | 30 minutes |
Vehicle fitment
It fits the 2014–2015 and 2017–2018 INFINITI QX60 (Base, Hybrid) and the 2013–2018 Nissan Pathfinder (Platinum, Platinum Hybrid, S, SL, SL Hybrid, SV, SV Hybrid).
QX60 years outside 2014–2015 and 2017–2018 fall outside this fit, and Pathfinder years outside 2013–2018 do as well. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The circuits are rated at 7.5 amps, so keep trailer lighting loads within those limits. The listed install time is 30 minutes.
What’s included
Vehicle to trailer connector with harness. No further included hardware is named.









