Overview
The Currie CE-9807RLA is a rear lower control arm for the 2007–2018 Jeep Wrangler JK, including the Unlimited four-door trucks on the manufacturer fitment list. The arm is designed for the RockJock JK off-road suspension system and uses an adjustable-length body with Johnny Joint ends.
The position is rear lower, and the arms are used in RockJock kits for 2-door and 4-door models. Adjustable length lets the installer set the arm before the joints are tightened.
Key features
- Adjustable length arm for the rear lower position
- 2-1/2 inch Johnny Joint on the rod end
- Black powder coat finish
- Arms used in Currie RockJock kits
Rear axle geometry
Rear lower control arms carry the axle’s fore-aft load and set the pinion angle relative to the driveshaft. When the arms are changed, the axle can rotate under torque, so arm length matters as much as joint quality. Install the pair together so both sides carry the same load and the axle stays square.
Johnny Joint ends wear over time, especially on trails with rock contact. Check for play by hand at each service and look at the boot for splits. Rear arm replacement often goes along with checking the front lower arms and the track bar, since a change to one link alters how the others share load.
- Torque jam nuts after the arm is set
- Check driveline angles after installation
- Inspect boots at each oil change
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9807RLA |
| Position | Rear lower |
| Joint | 2-1/2 inch Johnny Joint |
| Tubing | .625 inch outside diameter x .250 inch wall DOM steel per the product summary; the full description gives 1.625 inch outside diameter, so confirm the size with Currie |
| Finish | Black powder coat |
| Quantity | Pair |
Vehicle fitment
The manufacturer fitment list gives 2007–2018 Jeep Wrangler (JK) with the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, plus the Unlimited versions of those trims.
The list does not include Jeep Wrangler TJ, LJ or JL arms, and no Jeep Gladiator. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rear lower arms set the axle’s fore-aft location, so check pinion angle and have the alignment verified once the pair is in place. Settle the tubing size question before fitting the arms.
What’s included
A pair of rear lower control arms with Johnny Joint ends and a jam nut on the threaded end. Count the arms and check the hardware against your installation before starting.







