Overview
The Currie CE-9807FLA is a pair of adjustable-length front lower control arms for the 2007–2018 Jeep Wrangler JK, covering 2-door and 4-door models. They are built for Currie’s RockJock JK off-road suspension system and use Johnny Joint ends so the axle can move through its travel.
Each arm lets you set the length during installation, which helps position the axle once the rest of the suspension is assembled. The arms are finished in semi-gloss black powder coat with gold zinc plated forged ends.
Key features
- Adjustable length for setting axle position
- 2-1/2 inch Johnny Joint rod end on one end
- 1-1/4 inch RH thread forged Johnny Joint with jam nut on the other end
- 1.625 inch outside diameter x .250 inch wall DOM steel tubing
- Semi-gloss black powder coat over the tubing
- Forged ends finished in gold zinc plating
Setting axle position
Front lower control arms hold the axle fore and aft while letting it travel up and down. When a lift changes the geometry, adjustable-length arms give a way to bring the axle back into a workable position. Setting the length is a step done with the suspension mostly assembled, so the arm is not forced into a position the joints cannot follow.
Pay attention to the joint ends during setup. Johnny Joints need room to articulate, and binding at full droop or full compression shows the length is set wrong. Once the arms are at the right length, tighten the jam nut so the threaded end stays put, and recheck the alignment and caster after the first drive.
- Set both arms to matching length
- Tighten jam nuts after the length is set
- Inspect joint boots at each service interval
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9807FLA |
| UPC | 70000452621 |
| Position | Front lower |
| Tubing | 1.625 inch outside diameter x .250 inch wall DOM steel |
| Ends | 2-1/2 inch Johnny Joint; 1-1/4 inch RH thread on the second end |
| Finish | Semi-gloss black powder coat; gold zinc plated forged ends |
| Quantity | Pair |
Vehicle fitment
The manufacturer fitment list gives 2007–2018 Jeep Wrangler (JK) with the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, plus the Unlimited versions of those trims.
The list does not include Jeep Wrangler TJ, LJ or JL arms, and no Jeep Gladiator. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lower control arms change axle position, so have the alignment and caster verified once the pair is installed. Set the adjustable length before the joints are fully tightened.
What’s included
A pair of front lower control arms, each with a 2-1/2 inch Johnny Joint rod end and a forged threaded end with jam nut.









