Overview
The Currie CHP-CF10 is a high pinion flange yoke for Ford 9 Inch and Ford 8.8 Inch axles. It is built to accept standard Dana Spicer companion flanges, so your existing companion flange can be used with it. It fits front or rear axle locations on these high pinion Ford axles.
Key features
- Specialty pinion flange for high pinion Ford axles
- Accepts standard Dana Spicer companion flanges
- Fits both front and rear axle locations
- Covers the Ford 9 Inch and Ford 8.8 Inch axle types
Flange and pinion setup
A flange yoke bolts to the pinion through the companion flange rather than sliding over splines, so the flange you already run is the one that matters. Check the flange face and bolt holes for wear, and inspect the pinion threads before the nut is torqued. A damaged flange can leak at the seal or cause driveline vibration.
High pinion axles have a different driveshaft angle than low pinion designs, which changes how the driveline loads the pinion bearings. Keep the driveshaft balanced after work on the flange, and recheck the pinion nut after the first trail runs. Replace the pinion seal when the flange comes off, since the old seal often has a worn sealing track.
- Inspect the companion flange face for wear
- Check pinion threads before torquing the nut
- Replace the pinion seal during flange service
- Rebalance the driveshaft if the flange is changed
Specifications
| Brand | Currie |
|---|---|
| Part number | CHP-CF10 |
| Manufacturer number | CURCHP-CF10 |
| UPC | 70000376355 |
| Axle location | Front or rear |
| Axle types | Ford 9 Inches, Ford 8.8 Inch |
| Flange type | Accepts Dana Spicer companion flanges |
Vehicle fitment
This flange yoke has no vehicle years, models or trims listed. It is matched to high pinion Ford 9 Inch and Ford 8.8 Inch axles, so check your rear axle type first.
Use it only on high pinion Ford axles, since other axle makes are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The yoke is designed to accept a standard Dana Spicer companion flange, so the flange you already run is the one used with it.
What’s included
The flange yoke only.
Not included: the Dana Spicer companion flange, which the yoke is designed to accept.








