Overview
The G2 Axle and Gear 90-2052-31U is a 1310 Series pinion yoke for the front Dana 44 axle on the Jeep Wrangler JK, 2007 through 2018. The product name identifies the JK Dana 44 front application, which is the basis for the vehicle fitment below.
G2 Axle and Gear offers several pinion flanges and yokes for different applications, built for increased strength and reliability. Many G2 yokes use U-bolt style mounting, which the brand says is preferred by racers and off-roaders. This yoke is a U-bolt style yoke, and it takes a 1310 Series U-joint.
Key features
- 1310 Series yoke
- U-bolt style mounting
- Front axle location
- Made for the Dana 44 front axle
Pinion yoke fitment
The pinion yoke connects the driveshaft to the pinion gear, and its U-joint series has to match the yoke. A 1310 Series yoke takes a 1310 U-joint, and driveshaft length and angle are set around that pairing. When a yoke is replaced, pinion nut torque and driveshaft angles should be checked afterward, since a wrong angle causes vibration and early U-joint wear.
Look at the old yoke for wear at the seal surface and the U-joint bores. A worn surface can leak fluid past the seal, and a loose yoke can change pinion preload. Compare the mounting style with the driveshaft and axle so the parts work as a set.
- Check the pinion seal surface for grooves
- Confirm the U-joint series before ordering
- Recheck driveshaft angle after installing
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 90-2052-31U |
| UPC | 631410122992 |
| Axle location | Front |
| Axle type | Dana 44 |
| U-joint series | 1310 Series |
| Mounting | U-bolt style yoke |
Vehicle fitment
This pinion yoke fits the Jeep Wrangler JK with a Dana 44 front axle, from model years 2007 through 2018. It applies to the front axle only, not the rear.
The yoke is named for the JK only, so the JL Wrangler and the Gladiator are not covered.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One pinion yoke.
Not included: the 1310 Series U-joint, which connects the yoke to the driveshaft.








