Overview
The 83502058 is a pinion yoke for AMC Model 20 axles, also known as the Dana Model 20. It uses a strap and bolt style and fits the rear driveshaft at the transmission position. It fits the 1976–1986 Jeep CJ5, CJ7 and J10 and the 1981–1985 Jeep Scrambler.
The strap and bolt style is different from a U-bolt yoke, so check the yoke design and the driveshaft position on your vehicle before ordering.
Key features
- Built for the AMC Model 20 axle
- Strap and bolt style
- Rear driveshaft at the transmission position
- Direct fit for the CJ5, CJ7, J10 and Scrambler
Checking the yoke before install
A strap and bolt yoke clamps to the pinion differently than a U-bolt design, so the yoke face, pinion threads and driveshaft flange should be checked before installation. Confirm the rear driveshaft runs to the transmission position on your vehicle, because a yoke that sits at a different point will not line up with the driveshaft as intended.
Use a new pinion nut when the yoke is replaced and tighten it to the torque specified in your service information. Check the pinion seal and bearing preload at the same time, since a worn bearing can cause vibration that is often blamed on the yoke. Replacing the pinion seal while the driveshaft is off is a practical habit.
- Check the yoke face for grooves before fitting
- Mark the driveshaft and yoke alignment before removal
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83502058 |
| UPC | 848399024470 |
| Axle | AMC Model 20 (also known as Dana Model 20) |
| Design | Strap and bolt |
| Position | Rear driveshaft at transmission |
| Fitment type | Direct fit |
Vehicle fitment
This pinion yoke fits the following vehicles:
- 1976–1983 Jeep CJ5
- 1976–1986 Jeep CJ7
- 1976–1986 Jeep J10
- 1981–1985 Jeep Scrambler
The 1984–2001 Cherokee (XJ) and 1987–1995 Wrangler (YJ) are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One pinion yoke, part number 83502058. No other hardware is named.









