Overview
The Currie 44-1330 is a pinion yoke made for Dana 44 axles so the larger 1330 series U-joint can be used. It fits front and rear Dana 44 axle locations.
Currie offers this yoke to run the 1330 series U-joint on Dana 44 axles. Because the yoke is tied to the Dana 44 axle and a 1330 joint, match both before fitting.
Key features
- Made for Dana 44 axles
- Accepts the larger 1330 series U-joint
- Fits front and rear axle locations
- Currie part number 44-1330
Matching the yoke and U-joint
A pinion yoke is the link between the pinion gear in the differential and the driveshaft U-joint. Its bore and splines must match the pinion, and the U-joint cups must fit the yoke ears exactly, so the joint size and the yoke size have to agree. Before buying a U-joint, measure your existing cups and confirm the series.
When a yoke is changed, the pinion seal usually comes out with it and is commonly replaced at the same time. Inspect the sealing surface on the new yoke for grooves or scoring, since a rough surface can wear a new seal quickly. Set pinion nut torque after the yoke is fitted and check it again after the first few drives.
- Measure existing U-joint cups before ordering
- Replace the pinion seal when the yoke comes off
- Check the yoke sealing surface for grooves
- Recheck pinion nut torque after the first drives
Specifications
| Brand | Currie |
|---|---|
| Part number | 44-1330 |
| UPC | 70000545786 |
| Axle type | Dana 44 |
| U-joint series | 1330 series |
| Axle location | Front or rear |
Vehicle fitment
No vehicle years or models are named. Fitment is by axle type, Dana 44, rather than by vehicle.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the U-joint and driveshaft are both 1330 series before fitting this yoke, since this part covers only the pinion yoke.
What’s included
Check the package contents against your installation before starting.









