Overview
The Crown Automotive J5463656 is a temperature control cable for Jeep CJ5, CJ7 and Scrambler vehicles from 1976 to 1986. It has a 21.5 inch overall length and comes with a knob, sold under part number J5463656.
It is a direct-fit replacement for the temperature control cable, and the fitment section below breaks out the years and trims for each Jeep model.
Key features
- Temperature control function
- Knob included
- 21.5 inch overall length
- Direct-fit design for the listed Jeep models.
Temperature cable troubleshooting
A temperature control cable runs from the dash control to the heater or climate valve at the firewall. When the cable stretches, sticks or the knob spins without moving the lever, the valve no longer reaches its full range and the cabin is hard to regulate. Older cables on these Jeep models often fail at the sheath end or the clip that holds the housing, so inspect both before assuming the control head is at fault. Pay attention to the firewall grommet as well, because a worn grommet lets heat and road noise into the cabin.
When you replace one, route the new cable with the same bends as the old one and avoid sharp kinks in the sheath, since kinks cause binding. Lubricate the inner wire lightly if the install allows it, and check that the knob travels its full range before closing the dash.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5463656 |
| UPC | 848399065916 |
| Type | Temperature |
| Overall length | 21.5 inch |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1976–1983 Jeep CJ5 models (Base, Golden Eagle, Laredo, Limited, Renegade), 1976–1986 Jeep CJ7 models (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade) and 1981–1985 Jeep Scrambler models (Base, Laredo, Renegade, SL, SR).
Jeep generations and models outside these years, such as the Wrangler or Cherokee, are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One temperature control cable with knob.









